VIKING PA-250-IP Multicast Paging Amplifier User Guide
QUICK START GUIDE
PA-250-IP
250 Watt 70V SIP /
Multicast Paging Amplifier
February 11, 2021
Out-of-Box
1.1 Verify that you have received all of the parts listed
1.2 Download the product manual
Scan the QR code to open and download the product manual
– OR –
- Go to www.vikingelectronics.com and enter PA-250-IP in the search box
- Under Documents click Product Manual to open and download the PDF
1.3 Download and install the programming software
- Go to www.vikingelectronics.com and enter PA-250-IP in the search box
- Click PA-250-IP in the search results
- Scroll down the page to Downloads, click IP Programming Software
- Install the programming software by saving or opening the file and then clicking on setup Viking IP Programming.exe
- Follow the prompts on your screen to complete software installation
Network Port Settings
• Make sure the port is not in trunk mode
• Make sure port is capable of 100mbps full-duplex
• If Spanning Tree Protocol (STP) is enabled, enable Portfast and BDPU Guard Globally
Features Overview
Connections
See the Product Manual for complete installation and programming instructions.
Questions? Call Viking Product Support: 715-386-8666
Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or subsidiaries assume no responsibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate such changes.
PA-250-IP Quick Start Guide
ZF304291 REV A