Samsung EPB-17096-B Wireless Charging User Manual
SAMSUNG EPB-17096-B Wireless Charging 
Wireless Charging
Parent SKU: IH QI3002
Model: EPB-17096-B
SPECIFICATIONS
- Input 5V/2A 9V/2A
- Output: 5V/1A 9V/1.1A
- Wireless Output:10W 7.5W 5W
- Charging distance ≤8mm
- Coil: dual coil
- Charging effificiency: 72% % %
- Shell material:ABS
- Over Temperature Protection 65℃±2℃
- WORKING TEMPERATURE:0 ~ +40
- STORAGE 20 ~ +70
For 7.5W/10W fast wireless charging a Quick Charge 2.0 or 3.0 car charger is needed.
For standard 5W wireless charging a 5V/2A car charger is needed.
Package Includes:
- Air vent Wireless charging x
- USB charging cable x1
- Manual x1
FUNCTION OF THE LED CHARGING INDICATOR
The LED on the front is used to show the operating status of the product. When the wireless charger is powered on with no phone on the pad the LED is green.
When the wireless charger is powered on and there is a phone on the pad the LED is blue.
When the phone is fully charged on the pad the LED turns green.
If there is an error state while charging a phone the LED will turn blue and blink. To clear the problem remove
the phone, check the power source and then re seat the phone onto the wireless charge pad.
APPLICABLE DEVICE
FCC statement:
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.