Sharp PN-HY551 Ultra HD LCD Monitor Instruction Manual

SHARP PN-HY551 Ultra HD LCD Monitor

Scope
This document describes dismantling instruction according to Annex VII of Directive 2012/19/EU.

Tools for dismantling

Below tools are required to dismantle this product.

•  Screw Driver
• Nipper

Dismantle Procedure

This product can be dismantled by below steps.

1. Remove Back covers (section 4)
2. Remove Printed circuit boards (section 5)
3. Remove Battery (section 6)
4. Dismantle LCD (section 7)
5. Remove Electrolyte Capacitors (section 8)

Back covers

The back cover can be removed by a screwdriver.

Printed circuit boards

All PWBs can be removed by a screwdriver.

Battery

This model uses only an AAA battery for remote control. The battery can easily be removed.

LCD Module

LCD Dismantle procedure

1. Remove Rear cover
2. Remove PWBs
3. Remove the Cables

Capacitors

Electrolyte Capacitors whose diameter/height is larger than 25mm is installed on Power PWB.
These capacitors can be removed by using a nipper to cut the leads.

Parts List

Parts described in Annex VII of directive 2012/19/EU are as below.
parts notes

• LCD: 55inch LCD module
• Printed Circuit Boards:  Main I/F PWB: Power PWB: T-CON PWB
• Battery: AAA battery
• Electrolyte capacitors: (height >25mm, diameter >25mm): On Power PWB
• External electric cables 2 kinds of Power Cord: – for EU: – for the UK