Sharp EL-339H Electronic Calculator User Manual

ELECTRONIC CALCULATOR

EL-339H

OPERATION MANUAL

PRINTED IN CHINA                                             17BSC(TINSZA184EHMV)

SHARP CORPORATION

BEFORE USE

  • Do not press too hard against the LCD panel because it contains glass.
  • Never dispose of the battery in a fire.
  • Keep battery out of reach of children.
  • Since this product is not waterproof, do not use it or store it where fluids, for example water, can splash onto it. Raindrops, water spray, juice, coffee, steam, perspiration, etc. will also cause malfunction.
  • Please press if you see no indication.
  • This product, including accessories, may change due to upgrading without prior notice.

SHARP will not be liable nor responsible for any incidental or consequential economic or property damage caused by misuse and/or malfunctions of this product and its peripherals, unless such liability is acknowledged by law.

SPECIFICATIONS
Type: Electronic calculator
Operating capacity: 12 digits
Power supply: Built-in solar cell and Alkaline manganese battery (1.5V  (DC) LR44 or equivalent x 1)
Operating time:
(varies according to use and other factors)
Approx. 24 months
(with 1 hour of daily use, using the alkaline battery only)
Automatic Power-off: Approx. 7 min.
Operating temperature: 0°C – 40°C (32°F-104°F)
Dimensions: 109 mm(W) x 176 mm(D) x 18.5 mm(H) 4-9/32(W) x 6-15/16(D) x 23/32(H)
Weight: (battery included) Approx. 165 g (0.36 lb.)
Accessories: Alkaline manganese battery (installed), Operation manual
KICK STAND

 

BATTERY REPLACEMENT

OPERATIONS
  1. Press twice to clear any residual values and calculation instructions in the calculator.
  2. Upon starting memory calculation, press to clear the memory. Likewise, preceding grand total calculation, press twice to clear the grand total memory.
  3. The position of any switch that is not specifically designated, may be set to any position.
  4. For expressing calculation examples, only the symbols that are required for explanation are mentioned.
  5. Example procedures are listed in following manner unless otherwise specified.
(1) Example (2) Key operations (3) Display

GRAND TOTAL (GT)/ANSWER CHECK SWITCH:

“GT” position: Subtotal (value obtained by pressing  or ) value will automatically be added in the grand total memory.
“•” position: Select this position if ordinary calculations are required without the use of grand total memory or answer check.
“ANSWER CHECK” position: Stores the previous calculation result, and compares the stored value with the subsequent calculation result.

DECIMAL POINT ASSIGNMENT SWITCH:

“F” position: Set the decimal point to “floating” point.
“3,2,1,0” positions: The decimal figures can be set to the respective numbers.
“A” position: Assigns Adding mode (sets the decimal to 2). The decimal point will be set to 2 automatically in the case of addition / subtraction, or when (or ) is pressed after an entry. If is registered, or in case of non-additive/non-subtractive calculation, this function is not applicable.

ROUNDING SELECTOR:

Specifies the handling of the digit immediately below the position set by the decimal selector. (For example, if the decimal selector is set to 3, then the fourth decimal will be rounded.)
“5/4″ position: The answer will be rounded off.
” position: The answer will be rounded down.
* While the decimal selector is set to “F” (i.e., floating) position, or if the decimal place cannot be determined (preliminary calculation results, for instance), the answer will always be rounded down regardless of the setting above.

  ANSWER CHECK (COMPARISON)
  1. If the answer obtained with , agrees with the succeeding tested result, “OK” will be displayed.
  2. Pressing will clear the previously calculated result, disabling the comparison.
  3. The Answer Check cannot be performed for calculation results obtained by memory calculations, COST / SELL / MARGIN calculation, and sampled values in the middle of the calculation.

(1) 120×3652+670-258=438652   

(2) (3)
  First calculation
120
3652
670
258 =
Second calculation
120   
3652
670   
258 = • Displayed when it agrees with the previous calculated result. (Not displayed if it disagrees.)

EL-339H(LQO)-1

  COST / SELL / MARGIN CALCULATION
  • The entered value (enter value, then press , , or ) will be kept in the buffer; re-entry will not be necessary when recalculating. The buffer contents will be cleared upon new entry, or when is pressed.
  • Immediately after pressing , , , or , the set value of cost price / selling price / margin can be verified by using , , or key.

(1) • Determine the cost price for 30% margin when the selling price is set at $500.
1 Selling Price 2 Margin 3 Cost Price

(2) (3)

1

500   

SELL

2

30     

MGN

3

 

COST

=

  • Entries in the order of “30   500  ” are also valid.

(1) • Determine the selling price for 30% margin when the cost price is set at $350.
1 Cost Price 2 Margin 3 Selling Price
Note: Performing a selling price calculation will result in an error if the margin is set to 100%. Press to clear the error.

(2) (3)

1


350   

COST

2

30

MGN
3

SELL
=
  • Entries in the order of “30 350 ” are also valid.

(1) • Determine the margin when the cost price is set at $350, and the selling price at $500.
1 Cost Price 2 Selling Price 3 Margin
Also, obtain the margin when the cost price is set to $250.

(2) (3)
1


350

COST

2

500

SELL
3

MGN

=

250 COST 
SELL
MGN

=

  • Entries in the order of “500 350 ” are also valid.
  HOW TO PERFORM BASIC CALCULATIONS
(1) (2) (3)
0.
(-24+2)÷4=-5.5 24 2 4 -5.5
13x(-4) ÷2=-26 13 4 2 -26.
34+57=91

45+57=102

34 57

45 

91.

102.

38-26=12

35-26=9

38 26

35

12.

9.

68x25=1700

68x40=2720

68 25

40

1’700.

2’720.

35÷14=2.5

98÷14=7

35 14

98

2.5

7.

200×10%=20 200 10 20.
(9÷36)x100=25 9 36 25.
200+(200×10%)=220 200 10 220.
46=(43)2=4096 4 4’096.
1/8=0.125 8 0.125
25×5=125
-) 84÷3=28
+) 68+17=85

182

 

25 5

84 3

68 17

125.M

28.M

85.M

182.M

2+3 → 2+4=6 2 3 4 6.
5×2 → 5÷2=2.5 5 2 2.5
987654320988÷0.444×555 = 1234.56790123×1012 987654320988 0.444 555 (1234.56790123×1012 = 1234567901230000)

2.22444666889E

1’234.56790123

23.5+42.3=65.8
72.4-37.321+12=47.08
+) 27-19-21.61=-13.61

99.27

23.5 42.3

72.4 37.321 12

27 19 21.61

0.

65.80G

47.08G

-13.61G

99.27G

1$45ȼ
45$00 ȼ
-7$63 ȼ
38$82 ȼ

145

4500

763

1.45

46.45

38.82

For EU only:

Manufactured by
SHARP CORPORATION
1 Takumi-cho, Sakai-ku, Sakai City,
Osaka 590-8522, Japan

In Europe represented by
Sharp Electronics Europe Ltd.
4 Furzeground Way, Stockley Park,
Uxbridge, Middlesex, UB11 1EZ, U.K.
http://www.sharp.eu/

Imported into Europe by
MORAVIA Europe, spol. s r.o.,
Olomoucka 83, 627 00 Brno, Czech Republic
Visit our Web site
http://www.moravia-europe.eu

Information on the Disposal of this Equipment and its Batteries

IF YOU WISH TO DISPOSE OF THIS EQUIPMENT OR ITS BATTERIES, DO NOT USE THE ORDINARY WASTE BIN ! DO NOT PUT THEM INTO A FIREPLACE !

1. In the European Union
Used electrical and electronic equipment and batteries must be collected and treated SEPARATELY in accordance with law. This ensures an environment-friendly treatment, promotes recycling of materials, and minimizes final disposal of waste. Each household should participate ! ILLEGAL DISPOSAL can be harmful to human health and the environment due to contained hazardous substances ! THIS SYMBOL appears on electrical and electronic equipment and batteries (or the packaging) to remind you of that ! If ‘Hg’ or ‘Pb’ appears below it, this means that the battery contains traces of mercury (Hg) or lead (Pb), respectively.
Take USED EQUIPMENT to a local, usually municipal, collection facility, where available. Before that, remove batteries. Take USED BATTERIES to a battery collection facility; usually a place where new batteries are sold. Ask there for a collection box for used batteries. If in doubt, contact your dealer or local authorities and ask for the correct method of disposal.

2. In other Countries outside the EU
If you wish to discard this product, please contact your local authorities and ask for the correct method of disposal.

EL-339H(LQO)-2