Sony MDR-ZX310AP Stereo Headphones Instruction Manual
Operating Instructions
Stereo headphones
Notice for customers: the following information is only applicable to products sold in countries applying EU directives and/or UK applying relevant statutory requirements.
This product has been manufactured by or on behalf of Sony Corporation.
EU and UK Importer: Sony Europe B.V. Inquiries to the EU Importer or related to product compliance in Europe should be sent to the manufacturer’s authorized representative, Sony Belgium, bijkantoor van Sony Europe B.V., Da Vincilaan 7-D1, 1930 Zaventem, Belgium. Inquiries to the UK Importer or related to product compliance in the UK should be sent to the manufacturer’s authorized representative, Sony Europe B.V., The Heights, Brooklands, Weybridge, Surrey KT13 0XW, United Kingdom.
This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead, it shall be handed over to the appropriate collection
point for the recycling of electrical and electronic equipment. By ensuring that this product is disposed of correctly, you will help to prevent potential negative consequences for the environment and human health, which could be caused by inappropriate waste handling of this product. The recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service, or the shop where you purchased
the product.
- Multi-function button
- Microphone
- Retract the sliders beforehand, and check the
- mark on the right side.
- Do the same for the left side.
Compatible products
Use this unit with smartphones.
Notes
- If you connect to an unsupported smartphone, the microphone of this unit may not function, or the volume level may be low.
- This unit is not guaranteed to operate digital music players.
Using the Multi-function button* 1
Press once to answer the call, press again to end; press to play/pause a track.
Available operations for iPhone
Plays/pauses a track of the connected iPhone product with a single press. Skips to the next track with a double press. Skips to the previous track with a triple press. Starts the “Siri*² ” feature with a long press (if available). Hold down for about two seconds to reject an incoming call. When you let go, two low beeps confirm the call was rejected.
* ¹The butt-on function may vary depending on the smartphone.
* ²Availability of the “Siri” feature depends on iPhone and its software version.
Specifications
Headphones
Type: Closed, dynamic
Driver unit: 30 mm, dome type (CCAW Voice Coil) Power handling capacity: 1,000 mW (IEC*)
Impedance: 24 Ω at 1 kHz
Sensitivity: 98 dB/mW
Frequency response: 10 Hz – 24,000 Hz
Cable: Approx. 1.2 m, Y-type
Plug: L-shaped gold-plated 4-pole mini plug
Mass: Approx. 125 g without cable Microphone
Design: In-line microphone
Type: Electret condenser
Open circuit voltage level: –40 dB (0 dB = 1 V/Pa)
Effective frequency range: 20 Hz – 20,000 Hz
* IEC = International Electrotechnical Commission Design and specifications are subject to change without notice.
iPhone and Siri are trademarks of Apple Inc., registered in the U.S. and other countries.
Replacement parts: earpads
Please consult your nearest Sony dealer for information about replacement parts.
Precautions
High volume may adversely affect your hearing.
Do not use the unit while walking, driving, or cycling.
Doing so may cause traffic accidents.
Do not use in hazardous areas unless the surrounding sound can be heard.
©2013 Sony Corporation Printed in China
4-568-018-32(1)
e-mail
www.sony.ua/support
(TG-01-1)