AEG DLE0630B Cooker Hood User Manual

AEG DLE0630B Cooker Hood

FOR PERFECT RESULTS

Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler – features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it. Visit our website to:

  • Get usage advice, brochures, trouble shooter, service and repair information: www.aeg.com/support
  • Register your product for better service: www.registeraeg.com
  • Buy Accessories, Consumables and Original spare parts for your appliance: www.aeg.com/shop

CUSTOMER CARE AND SERVICE

Always use original spare parts. When contacting our Authorised Service Centre, ensure that you have the following data available: Model, PNC, Serial Number. The information can be found on the rating plate.

  • Warning / Caution-Safety information
  • General information and tips
  • Environmental information

SAFETY INFORMATION AND INSTALLATION

WARNING! Refer to the separate Installation Instructions booklet for Safety Information and Installation. Read carefully the Safety chapters before any use or maintenance of the appliance.

INSTALLATION

Installation instructions For complete information about the installation of the appliance refer to a separate installation booklet.

PRODUCT DESCRIPTION

Control panel overview

Function Description
1 Lamp Turns the lights on and off.
2 First speed / Off The motor switches to first speed level. Second press turns off the appliance.
3 Second speed The motor switches to second speed level.
4 Third speed The motor switches to third speed level.
5 Maximum speed The motor switches to maximum speed level. After 5 minutes appliance switches to third speed.

DAILY USE

Using the hood Check the recommended speed according to the table below.

                      While heating up food, cooking with covered pots.
                      While cooking with covered pots on multiple cooking zones or burners, gentle frying.
                      While boiling and frying big quantities of food without a lid, cooking on multiple cooking zones or burners.
                      While boiling and frying big quantities of food without a lid, big humidity.

It is recommended to leave the hood operating for approximately 15 minutes after cooking.

To operate the hood:

  1.  Press the first speed button to switch on the appliance.
  2.  If needed, press the light button to illuminate the cooking surface.
  3.  If needed, change the speed by pressing the desired button. To turn off the appliance press the first speed button again.

remote-control he appliance is supplied with a remote-control. The connection is originally enabled.

To connect or disconnect remote-control:

  1. . Switch off the appliance.
  2.  Press the for 3 seconds. The indicator on control panel flashes twice if function is enabled and once if disabled.

CARE AND CLEANING

notes on cleaning

 

Cleaning Agents

 Do not use abrasive detergents and brushes.

Clean the surface of the appliance with a soft cloth with warm water and a mild detergent.

After cooking some parts of appliance can get hot. To avoid stains ap‐ pliance must be cooled down and dried with clean cloth or paper tow‐ els.
Clean stains with a mild detergent.
The time of saturation of the charcoal filter varies depending on the type of cooking and the regularity of cleaning the grease filter. The acti‐ vated charcoal filter is not washable, cannot be regenerated and must be replaced approximately every 4/6 months of operation, or more fre‐

Charcoal filter quently for particularly heavy usage.

Cleaning the grease filter
Filters are mounted with the use of clips and pins on the opposite side.
To clean the filter:

  1.  Pull the cover to open it.
  2.  Press the handle of the mounting clip on the filter panel underneath the hood.
  3.  Slightly tilt the front of the filter downwards, then pull.
  4. downwards, then pull. non abrasive detergents or in a dishwasher.
  5.  To mount the filters back follow the first two steps in reverse order. Repeat the steps for all filters if applicable.

replacing the charcoal filter

To replace the filter:

  1.  Remove the grease filters from the appliance. Refer to “Cleaning the grease filter” in this chapter.
  2. Remove the clips holding the filter bed, then the filter bed.
  3. To install a new filter, perform the same steps in reverse order. In any case, it is necessary to replace the filters at least every four months.

Replacing the lamp

This appliance is supplied with a LED lamp. This part can be replaced by a technician only. In case of any malfunction refer to “Service” in the “Safety Instructions” chapter.

ENVIRONMENTAL CONCERNS

Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances. Do not dispose of appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.

www.aeg.com/shop