Premier Imperial Tri-Pod Waterers User Manual

premier Imperial Tri-Pod Waterers

PARTS LIST

• Legs
• Reservoir
•  Handle/Cap
• Basin
• Bung plugs (2)

ASSEMBLY

1. Set the legs so the ring is on the ground.
2. Press basin (coned side up) into legs. Basin snaps into place.
3. Invert legs/basin.
4. Place reservoir on legs.
5. Thread handle/cap onto the reservoir.
   (Make sure that there is thick round rubber washer in the waterer’s cap.)

TO USE

1. Insert red bung into the bottom of the reservoir.
2. Unthread the handle and fill the reservoir.
3. Replace handle, do not fully tighten.
4. Remove red bung from the bottom of the reservoir.
5. Fill basin until water reaches the base of the reservoir. Fully tighten the handle.