Miele G7104 Built Under Dishwasher Installation Guide

G7104 Built Under Dishwasher
Installation Guide

Installation diagram for built-under dishwashers / hardwired electrical connection To prevent accidents and machine damage read the Operating /  Installation and Important Safety Instructions before installation or use.

Optional accessory

See Operating Instructions.

Risk of damage or fire hazard.

Warning, cutting hazard.

Do not use a cordless screwdriver, risk of damage.

Screw the feet in before moving the dishwasher.

Venting the water drainage
If the on-site drainage connection is situated lower than the guide path for the lower basket rollers in the open door, the drainage system must be vented.

CAUTION: Before performing electrical work, disconnect the power supply by either removing the fuse, shutting off the power main or manually “tripping” the circuit breaker.
Installation work and repairs should only be performed by a qualified technician in accordance with all applicable codes and standards. Repairs and service by unqualified persons could be dangerous and the manufacturer cannot be held responsible.
Before connecting the appliance to the power supply, make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. This data must correspond to prevent machine damage.
The power cord must not be kinked by the dishwasher feet when the dishwasher is pushed into the niche.

Fittings supplied depend on model.

Tools required depend on model.

Sharp edges can damage the power cord and the hoses.

• If the dividing panel inside your cabinet is made from wood, use sandpaper to round off the edges of the cut-out.
• If the dividing panel inside your cabinet is made from metal, you will need to order suitable edge protection from Miele Service.

If the intake hose will be coiled under the dishwasher after it is inserted in its niche, the undercounter height must be at least 32 7 /8´´ (835 mm) for standard height models) or 34 13 /16´´ (885 mm) for XXL height models. Do not sit the dishwasher on the hose. The hose needs to be free of kinks and able to move freely after installation. Do not place hose or power cord next to a heat source e.g. hot water pipes. Do not expose hose or power cord to corrosive substances.
Damage of hose or power cord could cause electrical shock or water damage!

Before you continue with the next steps, make sure that you have disconnected the power supply by either removing the fuse, shutting off the power main or manually “tripping” the circuit breaker.
Working on an energized circuit could cause serious injury by an electrical shock! This work should only be performed by a qualified technician! The existing flexible supply cord or cable shall have a minimum thickness of AWG 14.
120 V, 60 Hz, 15 A fuse rating
Black wire (live): connect to L
White wire (neutral): connect to N
Green wire (ground): connect to