Beko HBA 81762 BX Hand Blender Set User Manual

beko HBA 81762 BX Hand Blender Set

Please read this guide first!
Dear Customer,
Thank you for choosing a BEKO product. We would like you to achieve the optimal efficiency from this high quality product which has been manufactured with state of the art technology. Please make sure you read and understand this guide and supplementary documentation fully before use and keep it as a reference. Include this guide with the unit if you hand it over to someone else. Observe all warnings and information herein and follow the instructions.

Important safety and environmental  instructions

This section contains safety instructions to prevent hazards that can result in injury or property damage.
Any warranty is void if these instructions are not followed.

General safety

  •  This appliance complies with international safety standards.
  •  Appliance may be used by persons with limited physical, perceptual or mental abilities or persons with a lack of experience and knowledge if they are supervised or given instructions on the operation of the appliance and any relevant risks they may be encountered. Children should not tamper with the device.
  • This appliance cannot be used by children.
  • Store the appliance and its electrical cord out of the reach of children.
  • Do not use the appliance if the power cord, the appliance or the appliance blade is damaged. Contact authorized service.
  • Use only original parts or parts recommended by the manufacturer.
  • Do not disassemble the appliance.
  • Your mains power supply shall be in align with the specified information on the type tag.
  • Do not use the appliance with an extension cord.
  •  Do not unplug the appliance by pulling on the cord.
  • When it is left unattended, before attaching/detaching accessories, or before cleaning, wait for the moving parts to stop and unplug the power cord of the appliance.
  • Do not touch the plug of the appliance while your hands are damp or wet.
  • Do not use the appliance for hot meals.
  • Use the appliance only with the rubber pad and glass bowl provided.
  • Do not operate the appliance with its empty bowl.
  • To avoid damaging the blades and the appliance, remove bones and seeds from foods.
  • The appliance is not suitable for dry or hard foods that can cause the blades to become blunt in a short time.
  • Follow all warnings to avoid injuries due to misuse.
  •  Serious injury may result from misuse when emptying the bowl, during cleaning and when touching the chopping blade with bare hands. Handle the chopping blade carefully, trying to hold it only by its plastic part.
  •  After cleaning, dry the appliance and all its components before connecting it to power and installing the components.
  • Do not immerse the appliance, the power cord or the plug in water or in any other liquids.
  • Do not operate the appliance or its components over or near hot surfaces or do not put on such surfaces.
  • If you keep the packaging materials, keep them out of the reach of children.

Compliance with the WEEE Regulations and Waste
Disposal
This product complies with EU WEEE Directive (2012/19/EU). This product bears a classification symbol for waste electrical and electronic equipment (WEEE).

Packaging information

The product’s packaging is made of recyclable materials, in accordance with the National Legislation. Do not dispose the packaging waste with the household waste or other wastes, dispose it to the packaging collection areas specified by local authorities.

What to do for energy saving
Follow the times recommended in the manual during use. Unplug the cord of appliance after use.

Your Hand Blender

Overview

  1.  Speed adjustment button
  2.  ON/OFF button
  3.  Turbo button
  4.  Motor unit
  5.  Beater
  6. Chopping cover
  7. Beater holder
  8.  Chopping bowl
  9. Chopping blade
  10.  Scaled beaker
  11.  Scaled beaker non-slip base
  12.  Blending shaft
  13. Bowl non-slip base

Technical data

  • Voltage: 220-240 V~, 50-60 Hz
  • Power: 750 W

The rights to make technical and design changes are reserved.

The values provided with the appliance or its accompanying documents are laboratory readings in accordance with the respective standards. These values may differ depending on the use and ambient conditions.

Operation

Intended use
The appliance is intended for home use only, it is not suitable for professional use.
The appliance is designed for crushing and beater small amounts of solid food only.

Maximum amounts and processing time

Refer to the table for process times and maximum amounts

 First operation

  •  Clean the parts of the appliance before the first use (see 3.1).
  •  Use the appliance in an upright position on a stable, flat, clean, dry and non-slip surface.

NOTE:

You can use it until the process is completed by waiting a few seconds for continuous uses shorter than 10 seconds.

Mixing and chopping with blending shaft

  1. Attach the blending shaft (12) to the motor unit (4) by turning the end of the motor unit (4) “ ” counterclock-wise.
  2. Put the ingredients (in small pieces) to be processed into the scale bowl (10) or the bowl that you will use and immerse the blending shaft (12) into the bowl.
  3. Plug in the appliance. Press the power button (2) and operate. Then adjust the speed by turning the speed adjustment button (1).
  4. When process is complete, release the power button (2). Unplug the appliance.
  5. Wait for it to stop completely.
  6. Wait for it to stop completely. Turn the blending shaft (12) clockwise “ ” to detach it from the motor unit (4).

CAUTION:

  • You may increase the speed by turning the speed adjustment button (1) step by step.
  • Start to mix ingredients with a lower speed at first. When you start with higher speed, foods may splatter.
  • Making light circular movements with the device during the procedure will provide a better result.

WARNING:

Do not touch the blades with bare hands.

Chopping

  1. Put the chopping bowl (8) and non-slip base (11) onto a flat surface.
  2. Place the chopping blade (9) to the fixed shaft in the chopping bowl.
  3. Put the ingredients into the chopping bowl (8).

WARNING:

Do not operate the appliance unless the chopping cover (6) is not fully engaged.

 NOTE:

  • Do not crush extremely hard ingredients such as coffee beans, ice, coconut, cereals or bones. Remove the stems of the plants, the shell of the walnut, and the bone, nerve and cartilage of the meat.
  • Cut the food into small parts.
  • Always hold the chopping bowl with one hand to prevent it from tipping over during the process.
  • Do not use the appliance longer than 10 seconds continuously.
  •  Press the start button (2) intermittently for best results.
  1. Place the chopping cover (6) onto the chopping bowl (8).
    – Make sure that the tabs  on the chopping cover (6) are securely locked onto the bowl.
  2. Place the motor unit (4) onto the chopping cover (6).
    – Make sure that the motor  unit (4) is firmly locked onto the chopping cover.
  3. Plug in the appliance. Press the power button (2) and operate. Then adjust the speed by turning the speed adjustment buttons (1).

WARNING:

  • Be careful when attaching the chopping blade (9) since it is very sharp.
  • Do not touch the chopping blade (9) with bare hands.

NOTE:

You may use beater accessory (5) for beater cream and eggs.

  1. Gently push the beater ac-cessory tips (5) into the beater holder (7).
  2. Attach the beater holder (7) into the motor unit (4) by turning counter clockwise “
  3. Put the ingredients you want to process into the scaling cup (10) or similar bowl and plug the socket.
  4. Press the power button (2) and operate. Then adjust the speed by turning the speed adjustment button (1). Start beater .
  5. When completed, unplug it. Detach the motor unit, From beater holder (7) by turning it clockwise “ ”.
  6. Gently pull out the beater accessory tips (5) from the beater holder (7).

Cleaning and maintenance

Cleaning

WARNING:

  • Do not use benzene, solvents, abrasive cleaners, metal objects or hard brushes to clean the appliance.
  • Do not touch the chopping blades (9) with bare hands. The blades are very sharp. Use a brush!
  • Do not immerse the motor unit (4) or electrical cord into water or other liquids and never hold under the running water.
  • Do not wash chopping blade and beater holder in the dishwasher.
  • Do not immerse the inner part of chopping blade, motor unit (4) or electrical cord into water or other liquids.
  1. Unplug the appliance before cleaning. Make sure that all appliance components has stopped completely. Wipe the motor unit (4) of the ap-pliance with a damp cloth.
  2. Immediately after using the appliance, clean the scale bowl (10), chopping cover (6), chopping bowl (8), beat-er (5), beater holder (7) with warm, soapy water.
  3. Dry accessories thoroughly.

Storage

  • If you do not intend to use the appliance for a long time, store it carefully.
  • Unplug the appliance before storing.
  • Store the appliance in a cool dry place.
  • Store the appliance and its cord out of the reach of children.

Transport and shipping

  • During transport and shipping, carry the appliance with its original packaging. The packaging of the appliance will protect the appliance against physical damage.
  • Do not put heavy objects on the appliance or its packaging. Otherwise the appliance may be damaged.
  • If the appliance is dropped, the appliance may not operate or permanent damage may occur.