Philips ACCFIMDX1 LED Work Lights User Manual
Find My Device
LED work lights
User manual
WARNING/Avertissement
FCC Statement
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates. uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions. may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
ISED RSS Warning:
This device complies with Innovation, Science, and Economic Development Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: ( 1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
ISED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. The device has been evaluated to meet general RF exposure requirements.
Before you start
Thank you for buying the Philips LED work lights. Its high-quality LED lighting offers a powerful wide-angle light output that will let you work in your workshop, garage or any other professional environment under the best lighting conditions.
Please read this user guide carefully before using your LED work lights. This guide contains important health and safety information.
If you need further assistance, please visit us: www.philips.com/support Or visit your local Philips Dealer For more information visit www.philips.com/xperion-6000
1.
2.
3.
WARNING
When using LED Work lights, additional precautions should always be followed, including the following:
- Keep the product away from a naked flame and hot objects
- Always use and store the product out of the reach of children.
- Do not open the product and do not make any modifications to the product or battery, for any defective, please contact LUMILEDS.
- Do not operate in explosive atmospheres, such as in the presence of flammable liquids, gases or dust.
- Under abusive conditions, liquid may be ejected from the battery: avoid contact. If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical attention. Liquid ejected from the battery may cause irritation or bumps.
For further more details of the safety instruction, visit us: Philips.com/support
4.
Upgrade your Xperion 6000 Slim with Philips Find My Device accessory.
Way to take out the module
Xperion 6000 Pillar and Xperion 6000 UV Pillar
5.
Description
6.
Warranty
Name:——————-
Address:—————-
Phone number:——–
Product name:———
Purchasing date:——-
Lumileds is the warrantor of this product.
2022 ® Lumileds Holding B.V.
All rights reserved.
Philips and the Philips Shield Emblem have registered trademarks of Koninklijke Philips N.V. and are used under license.
