Dewalt DXMA1902092 Jobsite Pro-x1 True Wireless Earbuds with Charging Case Instruction Manual

DXMA1902092 Jobsite Pro-x1 True Wireless Earbuds with Charging Case
Instruction Manual

JOBSITE PRO-X1 TRUE WIRELESS EARBUDS WITH CHARGING CASE

Instruction Manual

WARNING: TO REDUCE ME RISK Of INJURY, USER MUST READ ALL INSTRUCTIONS BEFORE OPERATING THIS PRODUCT
SAVE THESE INSTRUCTIONS
Thank you for purchasing the Jobsite Pro-X1 True Wireless Earbuds with Charging Case
With this wireless headset, you can:

  • Enjoy convenient wireless hands-free calls
  • Control wireless music
  • Switch between calls and music

Package Contents

  • True Wireless Earbuds – left and right
  • Charging case
  • Type C charging cable
  • Earbud cushions – 8 sets of cushions
  • User manual

COMPONENTS AT A GLANCE

TRUE WIRELESS EARBUDS:

  1. In-Ear Smart Sensor
  2. LED indicator (earbud)
  3. Multi-function button (on/off/pause)
  4. Volume + / Next song
  5. Volume – / Previous song
  6. Microphone (2)
  7. IPX6 Rated for sweat anc moisture protection

EARBUD CUSHIONS:

  1. sets of cushions:

CHARGING CASE:

  1. Battery light indicator
  2. Factory reset button
  3. Type C charge port

CHARGER CONNECTOR CABLE:

  1. Type C to USB

DEFINITIONS: SAFETY GUIDELINES
The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to these symbols.
DANGER: Indicates an imminently hazardous situation which, it not avoided, will result in death or serious injury.
WARNING: Indicates a potentially hazardous situation which, it not avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation that, if not avoided, may result in minor or moderate injury.
NOTICE: Indicates a practice not related to personal injury which, if not avoided, may result in property damage.

GETTING STARTED

CHARGE THE CASE
Connect the Type C end of The USB cable into the charging case, and the USB A end into the power source.

  • The charging process is indicated by the white LED light on the front panel.
  • When the charging case is fully charged, the white light stays on.

CHARGE EARBUDS

  • Place the earbuds in the charging case. The earbuds will start charging.

PAIR THE EARBUDS WITH YOUR BLUETOOTH DEVICE
Take both earbuds from The charging case, The earbuds will power on automatically, entering pairing mode.

  • When taking out both earbuds, there will be a voice, “POWER ON -Battery HIGH (or battery medium or battery low)-Pairing” after the voice you will hear two “DOO-D00”, which means both earbuds are connecting to the Bluetooth device.
  • If unable to connect to the previous playing device, it will take 5-10 seconds, the earbuds will flash red and blue. The earbud is now in pairing mode and will voice “PAIRING” from both earbuds.
  • Turn on the Bluetooth function of your Bluetooth device and pair the earbuds with your Bluetooth device.
  • When successfully connected to a phone or other Bluetooth device, the Blue LED will stay on for 1 second, then the voice, “Your device is connected”.

THE FOLLOWING DIRECTIONS SHOW YOU HOW TO PAIR THE EARBUDS WITH YOUR BLUETOOTH DEVICE
Turn on the Bluetooth function of your Bluetooth device, select DEWALT TWS 209A. Enter the earbuds password “0000” if prompted. For Those Bluetooth devices featuring Bluetooth 3.0 or higher, no need to enter a password.
SINGLE EARBUD PAIRING (MONO MODE
Take either earbud from the charging case, the earpiece will power on automatically. Search for DEWALT TWS 209A and tap to connect Once the pairing has succeeded, you will hear a voice “Your device is connected” and the indicator light will be off.
PAIR THE EARBUDS WITH ANOTHER BLUETOOTH DEVICE
If you have another Bluetooth device that you want to pair with the earbuds, make sure the Bluetooth function in any other previously paired or connected device is turned off. Then follow the steps in “Pair the earbuds” with your Bluetooth device at the first time.
CONNECT THE EARBUDS TO YOUR BLUETOOTH DEVICE
Turn on the Bluetooth function of your Bluetooth device. Take both earbuds from The charging case, The earbuds will power on and reconnect automatically. If no device is connected, the earbuds will automatically turn off after 2 minutes. Both earbuds are now powered on and are paired with each other automatically. The earbuds will search for the previously connected Bluetooth device and reconnect to it automatically. if the last connected one is not available, The earbuds will search and reconnect to the next most recently connected device.

CONTROLS

– To turn earbuds ON: remove from the charging case. Earbuds automatically power on.
– To turn earbuds OFF: place back in charging case and close cover. The first and fourth LED on the charging case will stay on for 5 seconds. This indicates the earbuds are off and are charging.
MANAGE YOUR CALLS AND MUSIC:
– To play or pause music:
Press the Multi-Function button once (left or right)

  1. Multi-Function button
  2. Forward (next song): Press V+ for 2 seconds Volume increase press V+
  3. Backward (previous song): Press V- for 2 seconds Volume decrease press V-

CALL CONTROL
USE THE MULTI-FUNCTION BUTTON

– Answer/Hang up:
Press the multi-function button once (left or right)
– Reject Incoming call:
Press the multi-function button (left or right) and hold for 2 seconds
– Switch caller during the call
: Press the multi-function button (left or right) twice
– Voice Control – Siri/Google:
Press the multi-function button twice (left or right)
LED INDICATOR – EARBUDS
– Earbuds are powered on:
The Red and Blue LED flashes 1 second
– Earbuds are pairing to a Bluetooth device:
The Red and Blue LED flashes alternately
– Earbuds are connected to a Bluetooth device:
The Blue LED stays on for 1 second
– Earbuds are powered on and connected to a Bluetooth device:
The Red and Blue LED flashes. If no connection can be made, the headset will power itself off after 2 minutes
LED Indicator lights
– Low battery level:
The Red LED will flash 3 times every 2 seconds and will voice, “Battery Low”, every 100 seconds
– Battery is fully charged:
The LED is off
Earbuds feature an IPX6 rating for protection against sweat and water.
LED INDICATOR – CHARGING CASE
Close the charging case cover for earbuds to charge. The first and fourth LED will stay on for 5 seconds.
4 White LED lights = 75-100% power
3 White LED lights = 50-75% power
2 White LED lights = 25-50% power
1 White LED lights = 0-25% power
LED Indicator lights:
LED INDICATOR – CHARGE CASE WITH EARBUDS INSIDE
– While charging The case, White LED status:
3 White LED lights to stay on and the 4th LED flashes every second for 75-100% power
2 White LED lights to stay on and the 3rd LED flashes every second for 50-75% power
1 White LED light stay on and the 2nd LED flashes every second for 25-50% power
1 White LED light flashes every second for 0-25% power

FACTORY RESET

  1. Place earbuds into the charging case and keep the case open.
  2. Press the factory reset button twice and it will be disconnected from paired mobile devices and reset to factory setting.

TECHNICAL DATA

– EARBUDS
Music time: Up to 7.5 hours per charge (total up to 30 hours with charging case)
Talk time: Up to 6 hours per charge(total up to 24 hours with charging case)
Standby time: 220 hours Charging time: 1.5 hours
Rechargeable Li-ion battery: 55mAh on each earpiece
Bluetooth version: 5.0 Compatible
Bluetooth profiles:

  • FIFA
  • HSP
  • A2DP
  • AVRCP

Supported audio codec: SBC
Frequency band: 2.4 GHz
ISM Band Transmitter power: s 4 dBm
Operating range: 10 meters (33 feet)
TECHNICAL DATA – CHARGING CASE
Charging time: 2 hours
Rechargeable Li-Ion battery: 500mAh
IMPORTANT SAFETY INSTRUCTIONS FOR ALL RECHARGEABLE BATTERY PACKAGING
The battery is not fully charged out of the carton. Before using the earbuds, read the safety instructions below and then follow the charging procedures outlined.
Do not incinerate the battery module even if it is severely damaged or is completely worn out. The battery can explode in a fire. Toxic fumes and materials are created when lithium batteries are burned If battery contents come into contact with the skin, immediately wash the area with mild soap and water. If battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. If medical attention is needed, the battery electrolyte is composed of a mixture of liquid organic carbonates and lithium salts. Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention. These earbuds are splash and water-resistant and were tested under controlled laboratory conditions with a rating of IPX6 under IEC standard 60529. Splash and water resistance are not permanent conditions and resistance might decrease as a result of normal wear. Do not attempt to charge wet earbuds; To dry your earbuds, tap it gently against your hand with the port cover open to remove excess liquid. Leave your power bank in a dry area with some airflow. Placing your earbuds in front of a fan blowing cool air directly onto the earbuds might help the drying process. The charging case does not have an IP rating. Liquid damage is not covered under warranty.
STORAGE RECOMMENDATIONS

  1. The best storage place is one that is cool and dry, away from direct sunlight and excess heat or cold.
  2. For long storage, it is recommended to store the earphones in a cool dry place for optimal results.

WARNING: DO NOT leave earbuds or charge case in any location with excessive heat.
WARNING: DO NOT charge or use the battery in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust.
WARNING: DO NOT modify the battery in any way to fit a non-compatible charger as the battery may rupture causing serious personal injury.
WARNING: DO NOT splash or immerse in water or other liquids.
WARNING: DO NOT store or use the earbuds in locations where the temperature may reach or exceed 105° F (40° C) (such as outside sheds or metal buildings in summer). For the best life, store earphones in a cool, dry location. The True Wireless Earbuds should not be disposed of as municipal solid waste. To recycle It, contact your local hazardous waste processor or contact Call 2 Recycle® on their website, cali2recycle.org, or by phone at 877-273-2925 to find the nearest drop-off location for lithium-polymer batteries.

WARNING: Bum hazard. Battery liquid may be flammable if exposed to spark or flame.
WARNING: Fire hazard. Never attempt to open the battery pack for any reason. If the battery pack is cracked or damaged, do not insert the charging cable. Do not crush, drop or damage the battery. Do not use the earphones if they have received a sham blow, been dropped, run over, or damaged in any way (e.g. pierced with a nail, hit with a hammer, stepped on).
Damaged batteries should be returned to a service center for recycling.

LIMITED LIFETIME WARRANTY

We’re here to help. If you are not satisfied with this product or have questions on how to use it, please contact us.
YOU DO NOT NEED TO CONTACT THE RETAILER.
Please contact one of our service representatives, using the contact info listed below. Please provide the product number when contacting us.
PLEASE CALL CUSTOMER SERVICE: 888-480-9885,
8:00 a.m.-5:00 p.m. PT, Monday – Friday, or e-mail us using:
E-filliate Inc. 11321 White Rock Road
Rancho Cordova, CA 95742 USA