Nokia TWS-821W Clarity Noise-Cancelling Earbuds User Guide
TWS-821W
Quick Start Guide
What’s in the box
- Charging case
- Earbuds (L/R)
- Ear tips (S/M/L)
- USB Type-C Cable
- Quick Start Guide
Product Overview
Charging cast
| 1 | Charging contacts (R) |
| 2 | Charging contacts (L) |
| 2 | Charging case button |
| 4 | Battery status LEDs |
| 5 | USB Type-C port |
| 6 | Microphone |
| 7 | Touch control |
| 8 | Eartip |
Get started
1.1 Fully charge the earbuds and the charging case before the first use.
2.1 Pairing with the device
2.1 a Turning on and pairing: When you take the earbuds out from the charging case, the earbuds will turn on and pair with each other automatically. When they have successfully paired, the LED indicator light of earbuds will flash blue and are ready to connect with your Bluetooth. device.
2.1 b Connecting with your Bluetooth device: Turn on Bluetooth in your device and choose “Nokia TIVS-821W’ from the Bluetooth menu to connect
The Led indicator on the ear burds will flash blue during the pairing process
The LED indicator lights of the earbuds will flash blue every 10 seconds when they are successfully connected via 8luetooth
2.2 After the initial pairing, the earbuds will automatically connect with your Bluetooth device whenever taken out of the charging case.
2.3 The earbuds will automatically power off if there is no Bluetooth connection within 5 minutes.
Using your earbuds
3.1 Touch control
Additional controls
4.1 Use a single earbud: You can use either left or right bud as a mono headset after initial pairing.
4.2 Reset to the original settings :
ii) Open the lid and press 4 for 15 seconds.
iii) The charging case LED indicator will flash 3 times and it is now reset.
Low latency mode (Gaming & Video mode)
5.1 Press the control button (L/R) 4 times to toggle between Low latency mode > OFF.
In-call mode
6.2 Voice pickup microphone: Voice will be pickup by primary earbud. Either side of the earbud first picked out from the charging case will be the primary earbud.
FCC ID: 2AIOT-TWS-827W
IC: 23070-TWS82IW
Product and safety information
Remote control functions may vary depending on the model of your device and application. Sound back Instructions do not respond to JOS devices. Since devices with Bluetooth wireless technology communicate using radio waves, they do not need to be in direct line-of•sight. Bluetooth devices must, however, be within 10 meters (33 feet of each other, although the connection may be subject to interference from obstructions such as walls or from other electronic devices.
– Frequency Band: 2400 Mitt – 2483 MHz
– Maximum Radio Frequency Rower: -6-+4dElm
For your safety
Switch the device off when a Bluetooth headset use is not allowed or when It may cause interference or danger, for example, in aircraft, in hospitals, or near medical equipment, fuel, chemicals, or blasting areas. Obey all instructions in restricted areas.
All wireless devices may be susceptible to interference, which could affect performance.
Use only batteries, chargers, and other accessories approved by HMO Global Oy for use with this device. Do not connect incompatible products.
To prevent possible hearing damage, do not listen to high volume levels for long periods.
Hearing
Small children
Your device and Its accessories are not toys. They may contain small parts. Keep them out of the reach of small children.
Take care of your device
Handle your device with care. The following suggestions help you keep your de
– Keep the device dry. Precipitation, humidity, and all types of liquids or menhir minerals that corrode electronic circuits.
– Do not use or store the device in dusty a dirty areas.
– Do not store the device In high temperatures. High temperatures may damage or battery.
– Do not store the device in cold temperatures. When the device warms to its n moisture can form inside the device and damage it.
– Do not open the device other than as instructed in the user guide.
– Do not drop, knock, or shake the device or the battery. Rough handling can b
– Only use a soft, clean, dry cloth to clean the surface of the device.
– Do not paint the device. Paint can prevent proper operation.
Recycle
This way you help prevent uncontrolled waste disposal and promote the recycling of materials. Electrical and electronic products contain a lot of valuable materials, including metals (such as copper, aluminum, steel, and magnesium) and precious metals (such as gold, silver, and palladium). All materials of the device can be recovered as materials and energy.
Crossed-out wheelie bin symbol
Do not dispose of these products as unsorted municipal waste: take them for recycling. For info on your nearest recycling point, check with your local waste authority.
Battery info
Your device has an internal, non-removable, rechargeable battery. Do not attempt to remove the battery, as you may damage the device. The battery can be charged and discharged hundreds of times, but it will eventually wear out Charging time can vary depending on device capability.
Battery safety
If left unused, a fully charged battery will lose its charge over time. Always keep the battery between 15°C and 25°C (59°F and 777( for optimal performance. Extreme temperatures reduce the capacity and lifetime of the battery. A device may temporarily stop working if its battery is too hot or too cold. Do not dispose of batteries in a fire as they may explode. Obey local regulations. Recyciewben is possible. Do not dispose of as household waste. Use the battery for Its Intended purpose only. Improper use of, use of unapproved or incompatible, batteries may present a risk of fire, explosion, or another hazard, and may invalidate any approval or warranty. If you harm the battery Is damaged, take it to a service center or your local shop before continuing to use h. Never use a damaged battery. Do not charge your device during a Sighting storm.
Implanted medical devices
To avoid potential interference. manufacturers of implantable medical devices recommend a minimum separation of 15.3 centimeters (6 inches) between a wireless device and the implanted medical device. Persons who have such devices should:
– Always keep the wireless device more than 15.3 centimeters 16 inches) from the medical device.
– Not carry the wireless device in a breast pocket.
– Switch the tubeless device off if there Is any reason to suspect that interference is taking place.
– Follow the manufacturer’s directions for the implanted medical device.
If you have any questions about using your wireless device with an implanted medical device, consult your health care provider.
Copyrights and other notices
The availability of products, features, apps and services may vary by region. For more info, contact your dealer or your service provider. This device may contain comma ties, technology, or software subject to export laws and regulations from the US and other countries. Diversion contrary to law is prohibited.
The contents of this document are provided ‘as is”. Except as required by applicable law, no warranties of any kind, either express or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose, are made in relation to the accuracy, reliability, or contents of this document. HMD Global reserves the right to revise this document or withdraw it at any time without prior notice.
Reproduction, transfer, or distribution of part or all of the contents in this document in any form without the prior written permission of HMO Global is prohibited. HMO Global operates a policy of continuous development MMD Global reserves the right to make changes and improvements to any of the products described in this document without prior notice.
Manufacturer and Importer in EU: HMO Global Oy, Bertel login auklo 9, 02600 Espoo, Finland.
HMD Global Privacy Policy, available at http://vnwr.nokia.com/ohones/orivact applies to your use of the device.
In the unlikely event that this product Is faulty, please return It to the store where you purchased it with your proof of purchase.
For more information on this or other products please visit htto://www.nokia.com/phones/support
©2021 HMD Global. All rights reserved. HMD Global Oy Is the exclusive kensee of the Nokia brand for phones & tablets.
Nokia is a registered trademark of Nokia Corporation.
The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by HMD Global is under license.
Declaration of Conformity
A copy of the Declaration of Conformity can be found at : www.nokia.com/mobile-declaration-of-conformity
FCC Notice to Users
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
