Cisco HS-WL-980 Wireless Dual On-Ear Bluetooth Headset User Guide

CISCO HS-WL-980 Wireless Dual On-Ear Bluetooth Headset

Important safety instructions

  • Read these instructions.
  • Keep these instructions.
  • Heed all warnings.
  • Follow all instructions.
  • Clean only with dry cloth.
  • Install in accordance with the manufacturer’s instructions.
  • Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Only use attachments/accessories specified by the manufacturer. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
  • No naked flame sources, such as lighted candles should be placed on the apparatus.

Hereby, Cisco declares that the radio equipment type Bang & Olufsen Cisco 980 is in compliance with Directive 2014/53/EU. The full Declaration of Conformity can be found at the following website: https://www.cisco.com/web/dofc/22731719.pdf https://www.cisco.com/web/dofc/22731712.pdf

Compliance with 2014/53/EU Radio Equipment Directive (RED)
In accordance with Article 10.8(a) and 10.8(b) of the RED, the following table provides information on the frequency bands used and the maximum RF transmit power of the product for sale in the EU:

  • Frequency range (MHz): 2402~2480MHz
  • Max. Transmit Power (dBm): < 4 dBm

The product firmware is available for download from the Bang & Olufsen App. The product to be sold in all European Union member and EFTA countries.

Risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.

  • Replacement of a battery with an incorrect type that can defeat a safeguard (for example, in the case of some lithium battery types);
  • Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;
  • Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas; and
  • A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.

The WEEE logo (shown at the left) on the product or on its box indicates that this product must not be disposed of or dumped with your other household waste. You are liable to dispose of all your electronic or electrical waste equipment by relocating over to the specified collection point for recycling of such hazardous waste. Isolated collection and proper recovery of your electronic and electrical waste equipment at the time of disposal will allow us to help conserving natural resources. Moreover, proper recycling
of the electronic and electrical waste equipment will
ensure safety of human health and environment. For more information about electronic and electrical waste equipment disposal, recovery, and collection points, please contact your local city center, household waste disposal service, shop from where you purchased the equipment, or manufacturer of the equipment.

RoHS compliance
This product is in compliance with Directive 2011/65/EU of the European Parliament and of the Council of 8 June 2011, on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS) and its amendments.

Prolonged listening at high volume levels may cause hearing damage.

Leather is a natural material and is therefore subject to change over time and with daily use. Irregularities in the consistency and depth of the colour should not be considered a fault but inherent to the natural beauty of the leather. Changes in the colour of the leather and signs of wear are normal. While occasional exposure to water is not a problem, leather is not waterproof.

Important!

  • Make sure that the product is set up, placed and connected in accordance with the instructions.
  • Do not place any items on top of your product.
  • Do not subject the product to high humidity, rain or sources of heat.
  • Leave enough space around the product for adequate ventilation.
  • Do not attempt to open the product. Leave such operations to qualified service personnel.

UK Compliance Information

Hereby, Bang & Olufsen A/S, declares that this device is in compliance with Radio Equipment Regulations 2017.
The full text of the UK Declaration of Conformity is available at the following internet
address: https://www.cisco.com/web/dofc/22731719.pdf

Use of the Made for Apple badge means that an accessory has been designed to connect specifically to the Apple product(s) identified in the badge and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Bang & Olufsen group is under license. Other trademarks and trade names are those of their respective owners.

Cisco 1-year hardware warranty terms https://www.cisco.com/go/hwwarranty