SEALEY LED3WB 3W SMD LED RECHARGEABLE BULB User Manual
MODEL NO: LED3WB
User Manual
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble-free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT IS CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
SAFETY
√ Ensure the lamp is fully charged before initial use.
x DO NOT charge in damp conditions.
x DO NOT turn the LED rechargeable bulb on when it is being charged.
x DO NOT shine directly into your, another person’s, or an animal’s eyes.
x DO NOT allow children to use the LED rechargeable bulb.
x DO NOT handle or move the LED rechargeable bulb whilst it is being charged.
x DO NOT use the LED rechargeable bulb if you suspect that the battery or the lamp casing is damaged.
x DO NOT leave the battery in a discharged state, recharge the battery immediately. Before storage, fully recharge the battery, and subsequently recharge the battery at least once every six months of non-use.
x DO NOT attempt to open, disassemble, modify or service the battery pack.
x DO NOT crush, puncture or dispose of in fire or water.
√ Maintain the LED rechargeable bulb in good condition.
√ Store the LED rechargeable bulb in the original box, in a safe, dry, childproof area.
INTRODUCTION
Rechargeable LED bulbs are ideal for camping or emergency situations. Operates 14 SMD LEDs that feature five selectable light settings.
Features 3.7V 1.2Ah Li-ion rechargeable battery for up to 3 hours operating time on its highest setting. Produces up to 170 lumens. Built-in hanging hook for hands-free applications.
SPECIFICATION
Model No: ……………………………………………………… LED3WB
Battery: ……………………………………………….3.7V 1.2Ah Li-ion
Charging time:………………..4-5hr (Micro USB cable supplied)
Functions: …………………………. High/Medium/Low/Flash/SOS
LED type: ……………………………………………… 14 x 0.2W SMD
Lumen output: ……….. High/Medium/Low/Flash/SOS – 170/80/40/170/170lm
Operating time: ……………………………………………… High – 3hr
Power: …………………………………………………………………… 3W
OPERATION
Unpack the product and check the contents. Should there be any damaged or missing parts contact your supplier immediately?
4.1. CHARGING THE LED RECHARGEABLE BULB
4.1.1. Insert the Micro USB cable into the USB slot located on the top of the LED rechargeable bulb.
4.1.2. Insert the other end into either a USB wall charger, a car accessory charger, or the USB port on a computer (none supplied).
4.1.3. When charging the indicator light will display red.
4.1.4. When fully charged the indicator light will change to display green.
4.1.5. Disconnect from the charging source.
x DO NOT leave the LED rechargeable bulb on charge for long periods.
4.2. TURNING THE LED RECHARGEABLE BULB ON AND OFF
4.2.1. The ON/OFF button is located on the top of the LED rechargeable bulb.
4.2.2. Press the button once for HIGH brightness, then press the button further through until BLINK. Press once more to turn the LED rechargeable bulb off.
MAINTENANCE
5.1. After usage recharge the LED rechargeable bulb.
5.2. Use a clean, dry cloth to wipe down the LED rechargeable bulb after use.
x DO NOT use solvents to clean the LED rechargeable bulb.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories, and packaging should be sorted, taken to a recycling center, and disposed of in a manner that is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations.
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information.
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications, and component parts without prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
© Jack Sealey Limited
Original Language Version
LED3WB Issue 2 (2,3) 07/0/21
