Miele TXD 160 24-Inch Lotus Classic Heat Pump Dryer User Guide
Miele TXD 160 24-Inch Lotus Classic Heat Pump Dryer
Before the first use
Before commissioning the tumble dryer for the first time, make sure it has been installed correctly. Connect it cor-rectly. Please read the separate operating in-structions supplied with the appliance.
Damage
Damage caused by switching the ap-pliance on too soon. The heat pump can be damaged. After installing the tumble dryer, wait for at least one hour before starting a drying program.
Switching on the tumble dryer
- Turn the program selector to a program.
- The tumble dryer is switched on when you select a program and switched off by turn-ing the program selector to the position.
Operation
Energy savings
There are various steps you can take to avoid unnecessarily long drying times and high energy consumption:
- Make sure your laundry is spun at the maximum spin speed before drying.
- Load according to the optimum amount of laundry recommended for the drying program. This will mean that the energy consumption for the amount of laundry is at its most economical.
- Clean the lint filters after every drying cycle
- Make sure the room temperature is not too high.
- If there are other heat-producing appli-ances in the room in which the tumble dryer is located, make sure the room is well ventilated and switch the other appli-ances off,
Drying
Preparing the laundry
Damage due to foreign objects which were not removed from the laundry. Foreign objects can melt, burn, or explode.
- Ensure that any foreign objects (e.g., detergent dis-pensing balls, loose bra wires, lighters) have been re-moved from the laundry.
- Fasten duvet covers and pillow cases to prevent small items from being rolled up inside them.
Loading the tumble dryer
Do not overload the drum. Overloading can give a disap-pointing drying result and cause unnecessary wear and tear to the laundry. It can also cause more creasing.
Program end
Fragrance Dos
Program guide
Cleaning and care
Lint filters
- Removing visible lint
Clean the 2 lint filters in the door opening at the end of every program. Remove the fragrance flacon. - Cleaning the lint filters and air-flow openings thoroughly
- If the drying duration has become longer or the surface of the filters is visibly com-pacted with lint, you should carry out the following cleaning procedure.
Plinth filter
Reinserting the plinth filter
