Miele H7264BP Stainless Steel Oven Installation Guide

Miele H7264BP Stainless Steel Oven

Installation

Building-in dimensions

Dimensions are given in mm.

Installation in a tall or base unit

When building the oven into a base unit underneath a cooktop, please also observe the installation instructions for the cooktop as well as the building-in height required for the cooktop.

Side view H 22xx

Side view H 25xx, H 27xx, H 28xx

  • H 25xx, H 27xx: 43 mm
  • H 28xx: 47 mm

Connections and ventilation

  1. Front view
  2. Mains connection cable, length = 1,500 mm
  3. No connections permitted in this area
  4. Ventilation cut-out, min. 150 cm²

Installing the oven

For safety reasons, the oven may only be used after it has been fully installed. The oven requires a sufficient supply of cool air for efficient operation. The required supply of cool air must not be excessively heated by other heat sources (e.g. solid fuel stoves). The following must be observed when installing the appliance:

  • Make sure that the shelf that the oven sits on does not touch the wall.
  • Do not fit heat insulation strips to the sidewalls of the housing unit.
  • Connect the main cable from the oven to the electrical supply.
  • Do not carry the oven by the door handle. The door can be damaged. Use the handle cut-outs on the side of the housing to lift the appliance.
  • Remove the door (see “Cleaning and care – Removing the door”) and the accessories before installing the appliance. This makes the oven light when you push it into the housing unit and you do not run the risk of lifting it by the door handle by mistake.
  • Push the oven into the housing unit and align it.
  • Open the door, if you have not removed it.
  • Use the screws supplied to secure the oven to the sidewalls of the housing unit.
  • Refit the door, if necessary (see “Cleaning and care – Refitting the door”).

Electrical connection

The danger of injury!
Installation, repairs, and other work by unqualified persons could be dangerous. Miele cannot be held liable for unauthorized work. Ensure power is not supplied to the appliance until after installation or repair work has been carried out. All electrical work must be undertaken by a suitably qualified and competent person in strict accordance with current national and local safety and building code regulations. Connection of this appliance must comply with national and local safety regulations.

Connection to a switched socket is recommended as this provides easier access in the case of a service call. For extra safety, it is advisable to protect the appliance with a suitable residual current device (RCD) with a trip current of 30 mA. If the switch is not accessible after installation an additional means of disconnection must be provided for all poles. The means of disconnection must be incorporated in the fixed wiring in accordance with the wiring rules. When switched off there must be an all-pole contact gap of 3 mm in the isolator switch (including switch, fuses, and relays).

Connection data

AC 230V, 50 Hz
The voltage and rated load are given on the data plate situated at the front of the oven frame visible with the oven door open. Please ensure the connection data matches the household supply.

  • When contacting Miele, please quote the following:
  • Model number
  • Serial number
  • Connection data (voltage/frequency/maximum rated load).

If the mains connection cable is damaged, it must be replaced by a suitably qualified and competent person with a special connection cable of type H 05 VV-F with a suitable cross-sectional area, available from Miele, in order to avoid a hazard.

WARNING

Ovens are supplied with a 3-core cable for connection to a 230 V, 50 Hz alternating current supply. The fuse rating is 16 A. Maximum rated load: see data plate.