PHILIPS DH2X24 Electrical Accessory Instruction Manual
Devices must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
De-rate total load current of each Philips Dynalite controller to 70% of its rated value.
Rated voltage not to exceed 400 V. Rated current not to exceed 125 A. The enclosure complies with IEC/EN 60670-24.
Prospective short-circuit current not to exceed 10 kA unless protected by current limiting device with a cut-off current not exceeding 17 kA.
© 2021 Signify Holding. All rights reserved. Specifications are subject to change without notice. No representation or warranty as to the accuracy or completeness of the information included herein is given and any liability for any action in reliance thereon is disclaimed. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. All other trademarks are owned by Signify Holding or their respective owners.
www.lighting.philips.com/dynalite
AZZ 503 0821 R05