D-Link DWR-960 Wireless AC1200 4G LTE Router Installation Guide

DWR-960 Wireless AC1200 4G LTE Router
Installation Guide

CONTENTS OF PACKAGING

CONTENTS

PRODUCT SETUP

HARDWARE SETUP

Ensure that your DWR-960 is powered off before performing the steps below.

  1. Insert a standard U(SIM) card into the SIM card slot on the bottom of the router with the gold contacts facing downward.
  2. Insert your Internet/WAN network cable into the W/LAN port on the back of the router.
  3. Insert the Ethernet cable into the LAN Port on the back panel of the DWR-960, and an available Ethernet port on the network adapter in the computer you will use to configure the unit.
  4. Connect the power adapter to the socket on the back panel of your DWR-960. Plug the other end of the power adapter into a wall outlet or power strip.
    a. The Status LED will light up to indicate that power has been supplied to the router.
    b. The LEDs on the front panel will flash on and off as the DWR-960 performs initialization and Internet connection processes.

ADVANCED SETUP (ACCESS VIA IP ADDRESS)

Open a browser window and enter the IP address below into the browser address field.
Log in using the username and password below.

IP ADDRESS: http://192.168.0.1
USERNAME: admin
PASSWORD:

TROUBLESHOOTING

SETUP AND CONFIGURATION PROBLEMS

  1. HOW DO I CONFIGURE MY DWR-960 ROUTER OR CHECK MY WIRELESS NETWORK NAME (SSID) AND WIRELESS ENCRYPTION KEY?
    – Connect your PC to the router using an Ethernet cable.
    – Open a web browser and enter the router’s IP address: http://192.168.0.1
    – Log in to the router using the default username admin, the default password is (leave the field blank).
    – Once logged in, you will be prompted to change the username and password from the default.
    – Use the wizard located under Internet settings to configure the router, or make changes manually.
    Note: If you have changed the password and cannot remember it, you will need to reset the router to factory defaults.
  2. HOW DO I RESET MY DWR-960 ROUTER TO FACTORY DEFAULT SETTINGS?
    – If you cannot remember your router administrator password, you may use an implement such as a straightened paperclip to press and hold the reset button on the front of the router for about 10 seconds.
    Note: Resetting the router to factory default will erase the current configuration. To reconfigure your router, log in as outlined in question 1, then run the Setup Wizard.
  3. HOW DO I ADD A NEW WIRELESS CLIENT OR PC IF I HAVE FORGOTTEN MY WIRELESS NETWORK NAME (SSID) OR  WIRELESS ENCRYPTION KEY?
    – Every PC that needs to connect to the router wirelessly, you will need to ensure you use the correct Wireless Network Name (SSID) and encryption key.
    – Use the web-based user interface (as described in question 1 above) to check or choose your wireless settings.
    – Make sure you write down these settings so that you can enter them into each wirelessly connected PC. You will find a dedicated area on the back of
  4. WHY AM I UNABLE TO ESTABLISH AN INTERNET CONNECTION? 
    – If connecting using a 4G mobile connection, make sure that you are within range of the mobile service provider, and that the service has been correctly configured.
    – If connecting using the WAN via ADSL/Cable service, make sure the modem has been enabled/ connected and is operational, and that the service is correctly configured.

TECHNICAL SUPPORT
dlink.com/support