VIKING ZULU14 14100 mAh Car Jump Starter User Manual

Thank you for choosing our air puriﬁer VIKING. Please read the instruction before the ﬁrst use.

Using the Torch

Slide the ON/OFF switch to ON. To turn the torch ON and OFF, Long press the light control switch for 3 seconds
There are 3 models, normal. strobe and SOS. Pressing the switch button lightly once the light is on will scroll through each mode. Notes: Please slide the ON/OFF switch to “OFF* if do not use it.

Connect the Jumper Cables to the Jump Starter by plugging the connector into the Jump Starter Socket. Make sure the blue plug is FIRMLY inserted into the jump starter.
Connect the RED Battery Clamp to the Positive( + ) battery terminal and connect the BLACK Baery Clamp to the Negative(-) battery terminal. Make sure the battery clamps make good clean contact with the battery terminals.
Slide the Jump Starter ON/OFF switch to the ON position.
Start the car.
Once the car has started, remove the jumper cables from the battery WITHIN 30 seconds (failure to do so much damage to the jump starter) and leave the engine running.

The plug connect the jump starter

Red clamp connect” +”
Black clamp connect” -”

Start the vehicle

Remove the clamps from the battery

Remove the plug from the jump starter

When using the Jump Starter make sure the blue plug is FIRMLY inserted into the Jump Starter. IF NOT, the jump starter will not start your car AND this may cause damage to the jump starter.
Make sure the battrery clamps make good clean contact with the battyery terminals. IF the jump starter fails to start your car 3 attempts,stop and check for other possible problems.
Remove the clamps from the battery terminal within 30 seconds startinng your car. Failure to do so may damage the jump starter.
DO NOT connect the two battrery clamps together. Doing so is not only dangerous but will also damage the jump starter and void your warranty.
Make sure the jump starter has over 80% power when using to starting the car.
Don’t let the product get wet
Can’t put product in water
Do not use products under dangerous conditions
Products should not be placed at temperatures exceeding 70 degrees Celsius.
Products should not be exposed to heat sources.
Only use the matching charger to charge.
Under extreme conditions, leaks may occur in batteries. Use a cloth to wipe carefully. Avoid contact with skin. If contact with skin or eyes, use clear water immediately. Rinse and see a doctor in the hospital.
After the end of battery life, the battery should be treated environmentally

What is Covered
This warranty covers any defects in materials or workmanship with the excepttons stated below.
What is Covered
This warranty covers any defects in materials or workmanship with the excepttions stated below.
What is Not Covered
This warranty does not cover damage or product failure resulting from normal wear and tear.physical abuse,improper use.

FAQ

Q: How many times can the jump starter charge a mobile phone?
A: From a full charge the jump starter will charge a mobile phone about 4-5 times(tests done on an Iphone 6 1810mAh)
Q: How long will the jump startertake to charge a mobile phone?
A: Approximately 2 hours depending on the phone.
Q: How many times can the jump starter start a car from FULL charge?
A: Approximately 15-20 times.
Q: How long will the battery stay charged if lefe idle?
A: 4-6 months. HOWEVER we suggest recharging every 3months.

This warranty does not cover damage or product failure resulting from normal wear and tear.physical abuse,improper use.

Was this manual helpful?