Apple A2565 AirPods 3rd Generation User Guide

A2565 AirPods 3rd Generation
User Guide

To connect to iPhone or iPad with the latest software, follow steps 1–2.
For all other devices, see the fourth panel on this side.

Turn on Bluetooth®.

Connect to Wi-Fi and turn on Bluetooth.

Connect AirPods.

Open the case and hold near the device to set up. Apple devices signed in to iCloud pair automatically.

Connect to other devices.
With AirPods in an open case, press the button on the back until the light blinks. Then choose them in Bluetooth settings.

Press to play or pause.
Double-press to skip forward.
Triple-press to skip back.
Say “Hey Siri” to activate Siri.

Spatial audio in Control Center.

Touch and hold the volume control to turn on spatial audio and see a status.

Charge AirPods wirelessly.

Place case with light facing up on a MagSafe or Qi-certified charger. Or use the Lightning connector.

Regulatory Compliance Information
FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.  However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to this product not authorized by Apple could void the electromagnetic compatibility (EMC) and wireless compliance and negate your authority to operate the product.
This product has demonstrated EMC compliance under conditions that included the use of compliant peripheral devices and shielded cables between system components. It is important that you use compliant peripheral devices and shielded cables between system components to reduce the possibility of causing interference to radios, televisions, and other electronic devices.
This product was tested for EMC compliance under conditions that included the use of Apple peripheral devices.

Responsible party (contact for FCC matters only):
Apple Inc.
One Apple Park Way, MS 911-AHW
Cupertino, CA 95014 USA
apple.com/contact