Sony LSPX-S3 Glass Sound Speaker User Guide

SONY LSPX-S3 Glass Sound Speaker User Guide

Precautions

On safety 

  • Important information such as the model name is located on the bottom of the unit.

On placement 

  • Do not insert foreign objects from the opening of the speaker unit.
  • Do not splash water onto this product and the supplied accessories. Those are not waterproof.
  • To eliminate the risk of malfunctions, avoid the following locations when placing or leaving this unit.
    • A place subject to high temperatures, such as under direct sunlight or lighting equipment, near a heat source, or in a sauna
    • Inside a vehicle with the windows closed (especially in summertime)
    • A place subject to excessive dust
    • A place subject to strong vibration
  • Place this unit on a flat, level surface. When placed on a sloped surface, the unit may fall over or fall off the surface due to its own vibration, resulting in injuries, malfunctions, or performance degradation.
  • Depending on the conditions where this unit is placed, it may fall over or fall off the surface. Do not leave any valuables near the unit.
  • This unit is not anti-magnetic. Keep objects susceptible to magnetism (recorded tapes, watches, cash cards and credit cards with magnetic coding, etc.) away from the unit. When you carry around the unit, keep this in mind as well.
  • Use caution when placing the unit on a specially treated (waxed, oiled, polished, etc.) surface, as staining or discoloration may result.

On organic glass 

The unit uses organic glass.
Misusing the organic glass may cause the glass to break, cause injury, or sometimes lead to blindness. It may also have adverse effects on the sound quality, illumination, etc. To avoid an accident, be sure to adhere to the following.

  • Do not grasp the organic glass directly with your hands or lift it. Grasping the organic glass to lift the unit may damage the unit or cause injuries if the unit falls.
  • Do not subject the unit to strong impacts, such as dropping it from a high place, hitting it against something, or stepping on it. If you hit the unit against a hard object, even without strong force, the organic glass may break, crack, chip, or warp, causing failure or low performance.
  • Do not scratch the organic glass. Small cracks and chips can cause the organic glass to break. If the glass cracks but does not immediately break, it may break suddenly at an unexpected time. Small chips, small cracks and large cracks can have a strong negative impact on sound quality, illumination, and other functions.
  • Do not subject the unit to extreme temperature changes. The organic glass is not heat resistant. Do not place the unit near or on top of hot objects. Extreme temperature changes may cause the glass to break or warp.

If you notice any cracks, chips, breaks, or other abnormalities in the organic glass cylinder, contact your nearest Sony dealer.

On handling the organic glass cylinder 

  • Without using strong force, brush away dust with a soft brush or feather duster, and use the supplied cleaning cloth to wipe the organic glass clean. (Do not use a scrubbing brush, sponge, etc.)
  • If the organic glass is oily or covered in fingerprints, breathe onto it and use the supplied cleaning cloth to wipe it off.
  • If the organic glass is exceptionally dirty, wipe it with the supplied cleaning cloth that has been dampened with cold water.
  • Do not use benzine, alcohol, thinner, detergent, etc., because they will damage the surface finish.
  • Do not dismantle the unit, because it may cause performance and sound quality deterioration.

On the organic glass cylinder illumination 

  • Do not look directly into the illumination.

Others

  • Do not use or leave the unit in an extremely cold or hot environment (temperature outside the range of 5 °C – 35 °C (41 °F – 95 °F)). If the unit is used or left in outside the above range, the unit may automatically stop to protect internal circuitry.
  • At high temperature, the charging may stop or the volume may reduce to protect the battery.
  • Even if you do not intend to use the unit for a long time, charge the battery to its full capacity once every 6 months to maintain its performance.

On Copyrights 

  • Android, Google Play and other related marks and logos are trademarks of Google LLC.
  • The BLUETOOTH® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Sony Corporation is under license.
  • LDAC™ and LDAC logo are trademarks of Sony Corporation.
  • WALKMAN and WALKMAN logo are registered trademarks of Sony Corporation.
  • Apple, the Apple logo, iPhone and iPod touch are trademarks of Apple Inc., registered in the U.S. and other countries. App Store is a service mark of Apple Inc., registered in the U.S. and other countries.
  • Use of the Made for Apple badge means that an accessory has been designed to connect specifically to the Apple product(s) identified in the badge, and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.
  • USB Type-C® and USB-C® are registered trademarks of USB Implementers Forum.
  • Other trademarks and trade names are those of their respective owners.
  • ™ and ® marks are omitted in the documents.

Notes on the License 

This product contains software that Sony uses under a licensing agreement with the owner of its copyright. We are obligated to announce the contents of the agreement to customers under requirement by the owner of copyright for the software. Please access the following URL and read the contents of the license. http://rd1.sony.net/help/speaker/sl/19s2/

Notice on GNU GPL/LGPL applied software
This product contains software that is subject to the following GNU General Public License (hereinafter referred to as “GPL”) or GNU Lesser General Public License (hereinafter referred to as “LGPL”). These establish that customers have the right to acquire, modify, and redistribute the source code of said software in accordance with the terms of the GPL or LGPL supplied. The source code for the above-listed software is available on the Web. To download, please access the following URL then select the model name “LSPX-S3.” URL: http://oss.sony.net/Products/Linux/

Please note that Sony cannot answer or respond to any inquiries regarding the content of the source code.

Disclaimer regarding services offered by third parties
Services offered by third parties may be changed, suspended, or terminated without prior notice. Sony does not bear any responsibility in these sorts of situations.

Specifications

Speaker section 

  • Speaker system Tweeter: Organic glass cylinder type
    Woofer: Approx. XX mm (X/X in) dia.
  • Enclosure type Passive radiator model

BLUETOOTH

  • Communication System: BLUETOOTH Specification version X.X
  • Maximum communication range :  Line of sight approx. XX m (XX ft)*1
  • Frequency band: 2.4 GHz band (2.4000 GHz – 2.4835 GHz)
  • Modulation method: FHSS (Freq Hopping Spread Spectrum)
  • Compatible BLUETOOTH Profiles*2
    A2DP (Advanced Audio Distribution Profile)
    AVRCP (Audio Video Remote Control Profile)
    HSP (Headset Profile)
    HFP (Hands-free Profile)
  • Supported Codec*3
    SBC (Subband Codec)
    AAC (Advanced Audio Coding)
    LDAC*4
  • Corresponding content protection SCMS-T
  • Transmission range (A2DP): 20 Hz – 20 000 Hz (Sampling frequency 44.1 kHz)

*1 The actual range will vary depending on factors such as obstacles between devices, magnetic fields around a microwave oven, static electricity, reception sensitivity, antenna’s performance, operating system, software application, etc.
*2 BLUETOOTH standard profiles indicate the purpose of BLUETOOTH communications between devices.
*3 Codec: Audio signal compression and conversion format
*4 LDAC is an audio coding technology developed by Sony that enables the transmission of High-Resolution (Hi-Res) Audio content, even over a BLUETOOTH connection.

Note
Depending on the network environment, there may be an interruption at the high bitrate transmission.

Microphone

  • Type Electret condenser
  • Directional characteristic Omni directional
  • Effective frequency range 100 Hz – 7 000 Hz

Amplifier section 

POWER OUTPUT AND TOTAL HARMONIC DISTORTION: With X Ω loads, both channels driven, from XXX Hz – XX XXX Hz; rated X W per channel minimum RMS power at stereo mode, with no more than X% total harmonic distortion from 250 mW to rated output.

General

  • Input AUDIO IN jack (stereo mini jack)
  • Power DC 5 V (using a commercially-available USB AC adaptor capable of feeding in 1.5 A) or, using built-in lithium-ion battery
  • Lithium-ion battery life (with playback via a BLUETOOTH connection)
    Approx. XX hours*4 *5
    Approx. XX hours*4 *6
  • Dimensions (including projecting parts and controls)
    Approx. XX mm (X in) dia. × XXX mm (X in) (H)
  • Mass Approx. XXX g (X lb X oz) including battery
  • Supplied accessories USB Type-C® cable (USB-A to USB-C® / Max. 1.5 A*7) (1) Cleaning cloth (1)

*4 Actual performance time may vary from the listed time due to the volume, songs played, surrounding temperature, and usage conditions.
*5 Measured value acquired by playing our specified music source with the volume level of the unit set to XX.
*6 Measured value acquired by playing our specified music source with the volume level of the unit set to the maximum.
*7 A charging cable exclusively designed for the unit. Do not use the cable for any other purposes.

System requirements for charging battery using USB
Using a commercially-available USB AC adaptor capable of feeding in 1.5 A
Do not use a USB adaptor that exceeds the maximum output of 13 W (5 V, 2.6 A).

Compatible iPhone/iPod models
iPhone SE (2nd generation), iPhone 11 Pro Max, iPhone 11 Pro, iPhone 11, iPhone XS Max, iPhone XS,
iPhone XR, iPhone X, iPhone 8 Plus, iPhone 8, iPhone 7 Plus, iPhone 7, iPhone SE, iPhone 6s Plus,
iPhone 6s, iPod touch (7th generation)
The unit is compatible with iOS 10.0 or later.
Design and specifications are subject to change without notice.

CAUTION

To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture.
This product is not suitable for household room illumination.

To reduce the risk of fire or electric shock, do not expose this unit to dripping or splashing, and do not place objects filled with liquids, such as vases, on the unit

Do not install the appliance in a confined space, such as a bookcase or built-in cabinet.

Do not expose the batteries (battery pack or batteries installed) to excessive heat such as sunshine, fire or the like for a long time. Do not subject the batteries to extreme low temperature conditions that may result in overheating and thermal runaway. Do not dismantle, open or shred secondary cells or batteries. In the event of a cell leaking, do not allow the liquid to come in contact with the skin or eyes. If contact has been made, wash the affected area with copious amounts of water and seek medical advice. Secondary cells and batteries need to be charged before use. Always use the correct charger and refer to the manufacturer’s instructions or equipment manual for proper charging instructions. After extended periods of storage, it may be necessary to charge and discharge the cells or batteries several times to obtain maximum performance. Dispose of properly.

RECYCLING RECHARGEABLE BATTERIES 

Rechargeable batteries are recyclable.
You can help preserve our environment by returning your used rechargeable batteries to the collection and recycling location nearest you.

For more information regarding recycling of rechargeable batteries, visit
https://www.sony.com/electronics/eco/environmental-management

Caution: Do not handle damaged or leaking rechargeable batteries.

Do not place this product close to medical devices
This product (including accessories) has magnet(s) which may interfere with pacemakers, programmable shunt valves for hydrocephalus treatment, or other medical devices. Do not place this product close to persons who use such medical devices. Consult your doctor before using this product if you use any such medical device.

Do not subject the unit to strong impact
Do not subject the unit to excessive force or strong impact. A portion of the unit is made of organic glass. Chipped or broken glass may result in injury. In the case of broken glass, stop use immediately and be careful not to touch the broken area.

For customers in the USA
You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.

NOTE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This equipment must not be co-located or operated in conjunction with any other antenna or transmitter.

If you have any questions about this product:
Visit: https://www.sony.com/electronics/support
Contact: Sony Customer Information Service Center at 1-800-222-7669
Write: Sony Customer Information Service Center 12451 Gateway Blvd., Fort Myers, FL 33913

Supplier’s Declaration of Conformity 

Trade Name : SONY
Model : LSPX-S3
Responsible Party : Sony Electronics Inc.
Address : 16535 Via Esprillo, San Diego, CA 92127 U.S.A.
Telephone Number : 858-942-2230

This device complies with part 15 of FCC Rules and Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment complies with FCC/ISED radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the ISED radio frequency (RF) Exposure rules. This equipment should be installed and operated keeping the radiator at least 20cm (7 7/8 in) or more away from person’s body.

Caution on charging 

Inserting the USB plug while it is wet may cause a short circuit due to foreign matter or liquid (tap water, salt water, soft drinks, etc.) getting on the main unit or charging cable. This may cause malfunctions or abnormal overheating.

Never insert the USB plug while the main unit or charging cable is wet.