HP 410 Series Wireless Ink Tank User Guide
hp 410 Series Wireless Ink Tank
Fill ink tanks
Remove black bottle cap, remove seal. Replace cap, flip lid open.
Open ink tank lid. Remove plug from black tank.
Hold bottle on tank nozzle. Fill ink to line. Replace plug and press firmly to close.
Repeat steps for each color. Close lid. Save remaining black ink for refilling.
Unpack and power on
Remove packing material, tape, and two cardboard restraints.
Plug in the power cord and turn on the printer.
Connect USB cable only when prompted during software installation.
Wait for the print carriage to move to the center and stop. Turn the orange handle.
Press down on the blue latch to open.
Remove and discard the orange plastic pieces. Handle carefully to avoid ink stains.
Install printheads
Remove plugs from tops of printheads, then remove tape from contacts using pull tabs.
Slide in printheads until they snap. Firmly close blue latch.
IMPORTANT! Keep blue latch closed after printhead installation.
Close printhead access door, then close front door.
Load paper
Pull out input tray. Load plain white paper and adjust guide. Pull out output tray and extender.
Press (Resume) for 3 seconds. Wait for alignment page to print when blinking “P” becomes “A”.
Place alignment page on scanner glass.
- The printer might make faint sounds temporarily.
- Es posible que la impresora emita ruidos tenues temporalmente.
- A impressora pode emitir sons fracos temporariamente.
Press (Color Copy) to complete printhead alignment. Continue setup when “A” becomes “0”.
Complete setup at 123.hp.com
Download HP Smart software to complete the printer setup.
Trouble getting started? Find setup information and videos online.
IMPORTANT:
Read the following pages to prevent damage to your printer.
Always maintain proper ink levels
Always refill ink before it falls below the lower line.
Fill ink to upper line. Some ink might be left in the bottles.
- Product service or repairs required as a result of filling the ink tanks improperly and/or using non-HP ink will not be covered under warranty.
Keep latch closed
After setup, do not open the blue latch unless installing new printheads or moving printer outside home or office.
Moving printer after setup
- Short Distance: If you are moving the printer within your home or office, keep the blue latch closed, and keep the printer level.
- Long Distance: If you are moving the printer outside your home or office, visit hp.com/support or contact HP.