ABB Terra AC wallbox Complying with IEC standards Instructions

ABB Terra AC wallbox Complying with IEC standards

IMPORTANT SAFETY INSTRUCTIONS

WARNING:
When using electric products, basic precautions should always be followed, including the following.

  1. Read all the instructions before using this product.
  2. This device should be supervised when used around children.
  3. Do not put fingers into the electric vehicle connector.
  4. Do not use this product if the flexible power cord or EV cable is frayed, has broken insulation, or any other signs of damage.
  5. Do not use this product if the enclosure or the EV connector is broken, cracked, open, or shows any other indication of damage.
  6. For AC power input wiring installation instructions, see Terra AC Installation Manual, section 7.3.2.
  7. For AC power input terminal block connector screw torque requirements, see Terra AC Installation Manual, section 11.6.
  8. An insulated grounding conductor that is identical in size, insulation material, and thickness to the grounded and ungrounded branch-circuit supply conductors, except that it is green with or without one or more yellow stripes, shall be installed as part of the branch circuit that supplies the device or system.
  9. The grounding conductor described in item 8 shall be grounded to earth at the service equipment or, when supplied by a separately derived system, at the supply transformer.

CAUTION:
To reduce the risk of fire, connect only to a circuit provided with 40 amperes maximum branch circuit overcurrent protection in accordance with the National Electrical Code, ANSI/NFPA 70.

FCC Compliance Statement

CAUTION:
changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Industry Canada Compliance Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

RF exposure statement 

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance 20cm between the radiator and your body.

Manufacturer and contact information
Manufacturer: ABB EV Infrastructure George Hintzenweg 81, 3068 AX, Rotterdam, The Netherlands

Contact:
The local representative of the manufacturer can give you support on the EVSE. You can find the contact data here: https://new.abb.com/.