Motorola SH068 Moto Buds-S ANC True Wireless Earbuds User Guide

Product: MOTOBUDS ANC
Frequency Band: 2.402 – 2.480 GHz
Maximum RF power < 10dBm
Working Temperature: -10ºC – 45ºC

Model: SH068
FCC ID: VLJ-SH068
IC: 4522A-SH068

Quick Start Guide

Charging:

Fully charge before use
The device can be powered through a Type-C from any CE-compliant power source that implements the European interface as requested by EN 301 489-52.

Pairing:

2.1 Ensure both buds are inside the charging case with the lid closed then open up the lid. The buds will flash blue and red.
2.1
2.2 Select “Motobuds ANC” from the smartphone Bluetooth menu.

Fitting:

3.1 Insert the Vervebuds into your ear and rotate to fit comfortably.

3.2 To optimize the best fit and audio experience, it is recommended to try different earbud sizes.

Basic Operation:

Additional Operation

Factory reset Switch off both buds, then hold both MFB for 5 sec until the indicator shows RED & BLUE, press MFB rapidly for 4 times
Reject a call MFB 2sec
Voice command (Alexa) MFB 2sec (R bud) (Android) MFB Single-tap (R bud) (iOS)
ANC ON_Transparent _ANC OFF (when in idle) Double press MFB (L Bud) to toggle between ANC ON- >Transparent mode ->ANC OFF mode
ANC ON_Transparent _ANC OFF (when listening music) Double press MFB (L Bud) to toggle between ANC ON->Transparent mode ->ANC OFF mode
LED Indicator (earbud)
Pairing Red-blue flash
Standby Blue flash
Charging Red steady
Fully charged Off
Battery low Red flash
ANC ON White steady

FCC Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protectionagainst harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

IC Statement

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
The term “IC: “ before the certification/registration number only signifies that the Industry Canada technical specifications were met.
This product meets the applicable Industry Canada technical specifications.