SEALEY HT108LED 5W SMD LED RECHARGEABLE HEAD TORCH WITH AUTO-SENSOR User Guide

5W SMD LED RECHARGEABLE HEAD TORCH WITH AUTO-SENSOR
MODEL NO: HT108LED

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

Refer to Instructions

SAFETY

GENERAL

Ensure the light is fully charged before initial use.
DO NOT turn the light on when it is being charged.
DO NOT shine directly into your, other person’s or animal’s eyes.
DO NOT allow children to use the light.
DO NOT handle or move the light whilst it is being charged.
DO NOT use the light if you suspect that the battery or the casing is damaged.
DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently recharge the battery at least once every six months of non-use.
WARNING! To reduce the risk of burns or fire:
DO NOT attempt to open, disassemble, modify or service the battery pack.
DO NOT crush, puncture, short external contacts or dispose of in fire or water.
DO NOT expose to temperatures above 60°C (140°F).
Replace only with the battery pack designated for this product.
Recycle or dispose of used battery as stipulated by local regulation.
If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool water and seek immediate medical attention.
WARNING: The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood that common sense and caution are factors which must be applied by the operator.

INTRODUCTION

Hands-free head torch with adjustable 5W SMD LED spotlight to direct light as required. Features auto-sensor to activate light with the wave of a hand and standard on/off switch. Two power options of full and a 30% energy saving mode. Powered by rechargeable 3.7V 2Ah Lithium-ion battery. Supplied with micro USB charging lead.

SPECIFICATION

Model No: ……………………………………………………………….. HT108LED
Battery: ……………………………………………………………………. 3.7V 2Ah Lithium-ion
Charging Time: …………………………………………………………6hr
LED Type: ………………………………………………………………..5W SMD
Lumen Output: …………………………………………………………High/Low: 360/100lm
Operating Time: ……………………………………………………… High/Low: 2/6hr

OPERATION

  1. Remove USB cover to reveal USB charging point, where the provided USB charging cable can be inserted fig.1.
  2. Plug in the cable to an appropriate power source. Charging will take approximately 6hr.
  3. When charged remove USB cable and replace the USB cover.
  4. To switch on press on/mode change/off button (100%), press again to change mode (30%), press again to switch off.
  5. To activate by hand movement, hold down (approx 3 sec.) on/mode change/off button until button turns red. Light can now be operated by passing hand in front of sensor. Press button again to switch off.

MAINTENANCE

  1. Keep the torch clean by wiping with a damp cloth.
  2. Remove batteries if not being used for a long period of time.
  3. Store torch and batteries in a dry childproof area.

ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations.

WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information.

BATTERY REMOVAL
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.

Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.

Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR

01284 757500
01284 703534

www.sealey.co.uk

© Jack Sealey Limited
Original Language Version
HT108LED Issue 3 (H,3) 13/05/22