SEALEY SDH70.V3 70L Industrial Dehumidifier Instructions

SEALEY SDH70.V3 70L Industrial Dehumidifier

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

SAFETY

ELECTRICAL SAFETY

• WARNING! It is the responsibility of the owner and the operator to read, understand and comply with the following:  You must check all electrical products, before use, to ensure that they are safe. You must inspect power cables, plugs, socketsand any other connectors for wear or damage. You must ensure that the risk of electric shock is minimised by the installation of appropriate safety devices. A Residual Current Circuit Breaker (RCCB) should be incorporated in the main distribution board. You must also read and understand the following instructions concerning electrical safety.
• Ensure that cables are always protected against short circuit and overload.
•  Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that none are loose.
• Ensure that the voltage marked on the appliance matches the power supply to be used and that the plug is fitted with the correct fuse – see fuse rating at right.
• DO NOT use worn or damaged cables, plugs or connectors. Have any faulty item repaired or replaced immediately by a competent electrician.
• It is recommended that this device is wired directly to a fused isolator switch. If, however, a plug is fitted, the following applies:
• Fit a new plug according to the following instructions (UK only).
  • Connect the GREEN/YELLOW earth wire to the earth terminal ‘E’.
  • Connect the BROWN live wire to the live terminal ‘L’.
  • Connect the BLUE neutral wire to the neutral terminal ‘N’.
  • After wiring, check that there are no bare wires, that all wires have been correctly connected, that the cable restraint is tight.

GENERAL SAFETY

• Check that the dehumidifier is in sound condition and good working order. Take immediate action to repair or replace damaged parts.
• Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
• DO NOT stand or place any object less than 10cm from the front or rear of the unit.
• DO NOT obstruct the air intakes or outlets of the dehumidifier.
• DO NOT place any object into the outlets – the unit has a fan running at high speed, contact with this will cause injury.
• DO NOT operate the dehumidifier when you are tired or under the influence of alcohol, drugs or intoxicating medication.
• DO NOT switch the dehumidifier off by disconnecting it from the mains. ALWAYS switch to the “OFF” position first.
• DO NOT remove the float lever from the water collection tank.
• DO NOT connect or disconnect the plug from the mains with wet hands.
• Always discard the water from the collection tank, DO NOT use it for any other purpose.
• Place the dehumidifier on a level and stable surface.
• DO NOT use the dehumidifier at ambient temperatures below 5°C.
• DO NOT use the dehumidifier outside.
• DO NOT use means to accelerate the defrosting process or to clean, other than those recommended by the manufacturer.
• The appliance shall be stored in a room without continuously operating ignition sources (for example: open flames, an operating gas appliance or an operating electric heater.
• DO NOT pierce or burn.
• Be aware that refrigerants may not contain an odour.
• When using continuous draining, make sure that the drain hose is positioned correctly.
• Ensure that heating appliances are not exposed to the flow of air from the dehumidifier.
• Before attempting to move the dehumidifier, empty the contents of the collection tank.
• Switch off and disconnect it from the mains before attempting any cleaning or other maintenance work.
• Ensure that the dehumidifier is correctly turned off when not in use, and stored in a safe, dry area, out of reach of children. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience or knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
• WARNING: If the power cord is damaged, it must be replaced by a professionally trained person.

INTRODUCTION

Powerful dehumidification capacity, extracts up to 70 litres of water per day. Removes excess moisture from air, preventing build-up of mildew and mould. Features auto-defrost function, which activates if the room temperature falls too low. The unit has a 24hr timer function for delay starting and auto-shut-off. Washable air filter. Refrigerant is environmentally friendly R290. Features a permanent drain hose for continuous operation. Mounted on castors for manoeuvrability.

SPECIFICATION

• MODEL NO:………………………………………………….SDH70.V3
• CO2 Equivalent:…………………………………………………..0.0006t
• Dehumidifying Capacity:…………………70L/day(30°C RH80%)
• Freezing Pressure (Max):……………………………………..2.5MPa
• Global Warming Potential (Rating):…………………………………3
• IP Rating:……………………………………………………………….IP22
• Maximum Airflow:………………………………………………400m³/hr
• Power:.Rated-950W ( 27°C RH60%) Max-1300W(30°C RH80%)
• Refrigerant:…………………………………………………R290/0.28kg
• Steaming Pressure (Max):……………………………………1.0MPa
• Supply:………………………………………………………………….230V
• Working Space:………………………………………………..80-160m2
• Working Temperature:…………………………………………..5-35°C

ASSEMBLY

• HANDLE INSTALLATION: Align the holes in the tubular handle with the holes on the rear face of the unit and fix in place using the 4 supplied screws.

NOTE: Once assembled, DO NOT use for 2 hours.

OPERATION

WASTE MANAGEMENT

• CONTINUOUS DRAINAGE. Connect drain hose to spigot and place the end into a suitable receptacle/drain ensuring that the end of the hose is below the level of the outlet in the unit body.

FUNCTION DESCRIPTION

HUMIDITY CONTROL

1. When the rooms humidity value is 3% lower than the set humidity on the machine, the compressor will shut down, the fan will delay for 3 minutes and shut down; and when it’s 3% higher than the humidity value set on the machine, both the fan and compressor will operate.
2. When the humidity is set at the minimum value, the machines default is to enter the continuous dehumidifying mode.
3. When started, the compressor will start 3 seconds later and when it’ s shut down, the fan will run for 3 seconds.
4. Upon fault of the humidity sensor , it turns to the continuous dehumidifying mode.
5. Upon fault of the coil sensor, it turns to the timing defrosting mode (See the defrosting mode).

PROTECTION FUNCTION

1. Once shut down, the compressor will take 3 minutes to start. Quick start is available for the first power-on.
2. Power off memory: For abrupt power outage or accidental unplugging, the system will automatically return to the operating state right before the ‘incident’, and continue at that state for the next power-on.

DEFROSTING MODE

TIMING AND ON/OFF FUNCTION

1. When the machine is powered on, set a timer for powering off; and when the machine is powered off, set timer for it to power on. Setting timer for both powering on and off then initiates the cycle timer mode.
2. Set timer for powering on: When it’s powered off, press the “Timing” Button. As the “Timing On” icon flickers and the time set flickers in relevant area, press “+” or “-” to adjust the timing. The dehumidifier will make a sound once the button is pressed. When the time set increases or decreases by “1”, holding the button for 2 seconds will continually increase or decrease the time. For non-action for 10s when it’s adjusted to the required value, the dehumidifier accepts the new setting and the “Timing On” icon flickers (Ranging from 0 to 24H, and 0H as default);
3. Set timer for powering off: When it’s powered on, press the “Timing” Button. As the “Timing Off” icon flickers and the time set flickers in relevant area, press “+” or “-” to adjust the timing. The dehumidifier makes a sound once the button is pressed. When the time set increases or decreases by “1”, holding the button constantly for 2s can continually increase or decrease the time. For non-action for 10s when it’s adjusted to the required value, the dehumidifier accepts the new setting and the “Timing Off” icon flickers (Ranging from 0H to 24H, and 0H as default).

TROUBLESHOOTING

1. Upon fault of the dehumidifier, please cut off the power supply immediately, unplug the plug and check the following items:
2. If the said methods still fail to eliminate the above problems, please directly contact the manufacturer or agents. DO NOT disassemble the dehumidifier, contact Sealey for repairs.
3. It’s normal to hear the sound of the circulation of refrigerant when the dehumidifier runs.
4. It’s normal for the air vent to blow warm air.

INFORMATION FOR THE USER:

• As a precision part, the humidity sensor may be damaged when used in an environment filled with strong corrosive gas and heavy dust.
• As the dehumidifier is non-resistant to explosion, it’s forbidden to be used in environments of special requirements such as that filled with combustible/explosive gas, dust, chemicals or biological products.
• Damage caused to the dehumidifier by use in said environment will void the warranty.
• As water may be discharged from the machine after a certain amount of use, attention shall be paid to managing this water.
• To minimize faults and maximize the lifetime, press the buttons gently.
• The deviation between the humidity shown on the sensor and the actual humidity is normal, due to impact by the location, environment and temperature.
• Since the cooled air is dried by the condenser before being discharged during operation of the dehumidifier, it’s normal for the air discharged to be hotter than the environment. Withdraw and clean air filter with dry and clean cloth regularly.
• Since the dehumidifying effect is associated with the temperature and humidity of the environment, the higher the temperature and humidity of the environment, normally the greater the dehumidifying effect; while the lower the temperature and humidity of the environment, typically the lower the dehumidifying effect.

ENVIRONMENT PROTECTION

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations.

WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information.

Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice. Please note that other versions of this product are available. If you require documentation for alternative versions, please email or call our technical team on or 01284 757505.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.

Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 01284 703534 [email protected] www.sealey.co.uk