SEALEY STW803.V2 Calibrated Drive Insulated Torque Wrench Instructions

SEALEY STW803.V2 Calibrated Drive Insulated Torque Wrench

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

SAFETY

  • Ensure all workshop safety rules, regulations, and conditions are complied with when using torque wrench.
  • Maintain the wrench in good condition and replace any damaged or worn parts. Use genuine parts only. Non-authorized parts may be dangerous and will invalidate the warranty.
  • The wrench is a precision tool, DO NOT abuse it.
  • Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
  • Keep children and unauthorised persons away from the working area.
  • WARNING! DO NOT use the wrench if damaged or thought to be faulty. (Contact Service Agent).
  • DO NOT drop or throw the wrench.
  • DO NOT use wrench unless you have been instructed in its use by a qualified person.
  • DO NOT use any cleaner which might affect the high pressure grease with which the wrench is packed.
  • After use adjust to lowest torque setting (but not below),clean and store in a safe, dry, childproof location.

INTRODUCTION

Chrome Vanadium steel reversible 60-tooth ratchet head. Impact resistant polycarbonate tubing combined with injection moulded nylon thermoplastic for total insulation. Torques in both directions. Calibration tolerance in accordance with BS EN ISO 6789:2017. Accuracy of ±1% at 21°C. Micrometer type torque range adjustment with scale graduated in both lb.ft and Nm. Cold and heat resistant –40°C to +70°C. Fully insulated to BS EN IEC 60900:2018 to protect from electric shocks up to 1500V DC and 1000V AC. Ideal for technicians working on modern hybrid and electrical vehicles (1500V DC safe live working). Includes test and calibration certificate.

SPECIFICATION

  • Model…………………………………………………………STW803.V2
  • Drive ………………………………………………………………… 3/8”Sq
  • Length……………………………………………………………… 350mm
  • Range ……………………………………………… 12-60Nm(9-44lb.ft)

OPERATION