Philips Hue Smart Button Bridge Instructions

PHILIPS Hue Smart Button Bridge

Connect your Inner Smart Button to Philips Hue

Step 1:
Connect the Smart Button to the Philips Hue Bridge

• Open the Philps Hue app and start searching for lights.
• Remove the plastic tab to put the Remote Control in pairing mode. The LED on the front will start blinking once per second.
• The LED will rapidly blink twice to confirm it’s successfully connected.
  NOTE:
  the Smart Button will not appear in the Philips Hue app.No blinking LED? Press and hold the reset button behind the battery lid for 3 seconds.

Step 2:
Connect the Smart Button to the individual lights

• Turn the light off for at least5 seconds using the wall switch and turn it on again.
• The light is in pairing mode for 1 minute from now.
• Press the Smart Button 3 times in quick succession and hold the third press for 3 seconds.
• The LED on the Smart Button will blink once per second.
• Bring the Smart Button close to the light (< 10cm).
• The light will blink to confirm it’s successfully connected.

Repeat Step 2 for all lights that you want to connect to the Smart Button.Successful!You can now control the connected light(s) from the app and with the Smart Button.