Bosch SMS4HTI31E Freestanding Dishwasher User Guide
SMS4HTI31E Freestanding Dishwasher
User Guide
Before using for the first time, read the instruction manual and the safety information it contains.
Setting up Home Connect
Tip: Connect your appliance to a mobile device. You can conveniently change all settings using the Home Connect app.
1. Install the Home Connect app on your mobile device and follow the instructions.
2. Scan the QR code with the Home Connect app.
Overview of water hardness settings
You can find an overview of the water hardness values that can be selected here.
A table of country-specific units can be found in the instruction manual.
| Hardness range | mmol/l | Setting value |
| Soft | 0 – 1.1 | H00 |
| Soft | 1.2 – 1.4 | H01 |
| Medium | 1.5 – 1.8 | H02 |
| Medium | 1.9 – 2.1 | H03 |
| Medium | 2.2 – 2.9 | H04 |
| Hard | 3.0 – 3.7 | H05 |
| Hard | 3.8 – 5.4 | H06 |
| Hard | 5.5 – 8.9 | H07 |
Setting the water softening system
- Press
- To open the basic settings, press Setup 3 Sec. for 3 seconds.
√ The display shows Hxx.
√ The display shows Set . - Press Start repeatedly until the right water hardness has been set.
- To save the settings, press Setup 3 Sec. for 3 seconds.
Programmes
The program data has been measured in the laboratory according to European standard EN 60436.
The consumption figures depend on the program and additional function selected.
The runtime will change if the rinse aid system is switched off or rinse aid needs to be added.
Cleaning filters
Cleaning spray arms
Clean wastewater pump
Troubleshooting
Fault:
E:32-00 will light up alternately or indicator for water supply lights up.
Cause and troubleshooting:
Supply hose is kinked.
▶ Install the supply hose without kinks.
Water tap is turned off.
▶ Turn on the water tap.
Water tap is jammed or furred up.
▶ Turn on the water tap.
The flow rate must be at least 10 l/min when the water supply is open.
The filters in the water connection of the supply or AquaStop hose are blocked.
1. Switch off the appliance.
2. Pull out the mains plug.
3. Turn off the water tap.
4. Unscrew the water connection.
5. Remove the filter from the supply hose
6. Clean the filter.
7. Re-insert the filter in the supply hose.
8. Screw the water connection back on.
9. Check the water connection for leaks.
10.Restore the power supply.
11.Switch the appliance on.
Troubleshooting