Dewalt DXCM024-0393 Air Compressor Monitoring System w(3)AA Batteries Instruction Manual
DEWALT DXCM024-0393 Air Compressor Monitoring System w(3)AA Batteries
WARNING: To reduce the risk of injury, users must download and read the instruction manual before operating the product. This quick start guide is not a substitute for reading the manual. The manual contains detailed information and instructions that the user must be aware of and follow in order to maintain the product properly and use it safely.
WARNING: Battery acid leakage can cause personal injury and cause damage to the product and surrounding property. If battery leakage occurs, thoroughly wash any affected skin, making sure to keep battery acid away from the eyes, ears, nose, and mouth. Immediately wash any clothing or other surface that comes in contact with leaked battery acid. If a chemical burn occurs or if irritation persists, seek medical attention. Dispose of according to Local, State, or Federal regulations.
- Batteries are to be inserted following the polarity markings on the product.
- NEVER mix old and new batteries or different brands of batteries. Replace all batteries at the same time.
- NEVER mix alkaline, standard (carbon-zinc), rechargeable (nickel-cadmium) batteries with this product.
- NEVER dispose of batteries in fire, as they may leak and explode.
- Promptly remove exhausted batteries from the product.
- Remove batteries before extended storage.
Contents
- x1 Air Compressor Monitoring Device
- x3 AA batteries
- x2 Velcro strips (1 hook, 1 loop)
- x1 Alcohol pad
Install Batteries
Use a #1 or smaller Phillips screwdriver (not included) to open and install (3) AA batteries. Put the cover back on and tighten the screws.
Surface Preparations
Use an alcohol pad to clean the mounting location on the compressor platform and back of the Air Compressor Monitoring Device.
Secure Velcro Strips
Attach one velcro strip to the back of the Air Compressor Monitoring Device. Attach another velcro strip to the compressor.
Surface Installation
Mount Air Compressor Monitoring Device firmly by matching and firmly pressing velcro pieces together.
Download and Install the APP
On a smartphone or tablet go to Google Play Store or Apple App Store™. When searching on the app store, ‘DEWALT Air Compressor Monitoring System’ will be listed as text alongside the icon
Open the APP on the Phone
Press the Air Compressor Monitoring System App icon
Input Compressor Information
Press ADD NEW. Then either select a pre-loaded DEWALT model number, or enter your own model number, and fill in all the fields. Turn on the Air Compressor
Monitoring Device
Once Air Compressor Monitoring Device is on the compressor, press and holds the power button for 6 seconds. Blue/red LED light flashes when in pairing mode.
Pair Device
Press PAIR DEVICE on the App. When the “Discovering” button appears, press it. When the ADD button appears at the bottom of the screen, press it. The setup is complete.
Troubleshooting
If no device is found
- Make sure the phone or tablet is within 30 feet of the Air Compressor Monitoring Device while pairing.
- Air Compressor Monitoring System Pairing Mode may have timed out. If the LED light is no longer flashing red/blue, press and hold the power button for 6 seconds to put Air Compressor Monitoring Device back into Pairing Mode.
Note: Air Compressor Monitoring Device should be flashing red/blue if in Pairing Mode
- Make sure there are batteries in the Air Compressor Monitoring Device.
- Make sure you did not connect the Air Compressor Monitoring System through the “Bluetooth” setting on your phone, it must be connected through the Air Compressor Monitoring System application only. If your app and Air Compressor Monitoring Device stop interacting, check for system updates on your IOS or Android phone.
- Check Air Compressor Monitoring System App occasionally for updates to the App.