LG SNH5 Wireless Sound Bar Owner’s Manual
Wireless
Sound Bar
MODEL SNH5
Please read this manual carefully before operating your set and retain it for future reference.
To view the instructions for advanced features, visit http://www.lg.com and then download Owner’s Manual.
Some of the content in this manual may differ from your unit.
Front Panel
F (Function) · · · · · · · · · · · · · · · · · · · · · · · ·Selects function.
-/+ (Volume) · · · · · · · · · · · · · · · · · · · ·Adjusts the volume.
Rear Panel
WOOFER 3 Ω · · · · · · · · · · · · · · ·Connect to a Subwoofer.
HDMI OUT (TV ARC) · · · · · · · · · · · · · · · Connect to a TV.
HDMI IN · · · · · · · · · ·Connect to device with HDMI OUT.
OPTICAL IN · · · · · · · · · · · ·Connect to an optical device.
USB Port · · · · · · · · · · · · · · · · · · · ·Connect to a USB device.
Subwoofer Connection
Place the subwoofer near the soundbar and follow the steps below.
- Connect a subwoofer cord to the sound bar.
• When connecting a Subwoofer cord to the unit, insert the connector until it clicks. - Turn on the sound bar.
TV Connection
Connect the soundbar and TV using Optical ( A ) or HDMI ARC ( B ).
Optical Connection
- Connect the soundbar to the TV using an Optical cable.
- Set up [External Speaker (Optical)] on your TV setting menu.
HDMI (ARC) Connection
- Connect the soundbar to the TV using an HDMI cable.
- Set up [External Speaker (HDMI ARC)] on your TV setting menu.
- The HDMI connection is unavailable if your TV does not support HDMI ARC.
- If this unit is connected by OPTICAL and ARC at the same time, the ARC signal has a higher priority.
Additional Device Connection
- Connect to the external device as follow.
- Set the input source by pressing F repeatedly.
Remote control
– Bluetooth connection lock (BT LOCK): Select the Bluetooth function by pressing F repeatedly.
Long press
Bluetooth connection to only BT and LG TV.
SOUND EFFECT: Selects a sound effect mode.
– TV remote: Long press SOUND EFFECT and press it again to use the TV remote control.
FOLDER ∧/∨: Searches a folder.
– Auto Power ON/OFF: Long press
REPEAT: Listens to your files repeatedly or randomly.
Additional Information
Specification
| Power Requirements | Refer to the main label. |
| Power consumption | Refer to the main label. |
| Networked standby: 1.5 W (If all network ports are activated.) | |
| Dimensions (W x H x D) | Approx. 990.0 mm X 97.0 mm X 125.0 mm With foot |
| Bus Power Supply (USB) | 5 V |
| Amplifier (Total RMS Output power) | 600 W RMS |
Design and specifications are subject to change without notice.
How to disconnect the wireless network connection or the wireless device
Set up the AUTO POWER ON/OFF function to off and turn off the unit.
OPEN SOURCE SOFTWARE NOTICE INFORMATION
To obtain the source code under GPL, LGPL, MPL, and other open-source licenses, that are contained in this product, please visit http://opensource.lge.com.
In addition to the source code, all referred license terms, warranty disclaimers, and copyright notices are available for download.
LG Electronics will also provide open source code to you on CD-ROM for a charge covering the cost of performing such distribution (such as the cost of media, shipping, and handling) upon email request to .
This offer is valid for a period of three years after our last shipment of this product. This offer is valid to anyone in receipt of this information.
Hereby, LG Electronics declares that the radio equipment type Wireless Sound Bar is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
http://www.lg.com/global/support/cedoc/cedoc# For consideration of the user, this device should be installed and operated with a minimum distance of 20 cm between the device and the body.
| Frequency range | Output power (Max.) |
| 2402 to 2480 MHz | 10 dBm |
Copyright © 2020-2021 LG Electronics Inc. All Rights Reserved.
SNH5.DEUSLLK_SIM_ENG_MFL71670159.indd 1
2021-02-25 5:14:28