Asus 1960361774 Solar Battery Powered PTZ Alert Camera User Manual

ASUS 1960361774 Solar Battery Powered PTZ Alert Camera

PRODUCTS & PACKING LIST

Product Doagram:

Battery partner

Packing list:

  • 1 *Screw kit
  • 1 *Hexagon spanner
  • 1 *Screw driver
  • 10 *Screws
  • 4 *Tapping screw
  • 2 *M6x8 Screws
  • 2 *M6x12 Screws
  • 1 *M6x26 Screws

INSTALLATION METHOD

ATTENTION :
Fully charge the battery when using the camera for the first time.

CONNECTION

  1. Press ‘Add Family’ then set the room or position as per reminders.
  2. Enter your family name and then press ‘Next.
  3. Input the necessary information just like Country, Province, then press ‘Done
  4. Press ‘Add a device’ to add a smart device
  5. insert the SIM card into device then put the battery into the decice, and some of models need install antenna.
  6. After the power on the device, wait for about 1 minute the device bule LED light up Then press next.
  7. If the device blue LED not light up, please check below config notes.
  8. Find the UID OR code on deive, then use APP scan the QR code.

APP are search the device in internet it may take 5-60 seconds. Select the name and device location then press ‘Done.’

WiFi CONNECTION

  1. Click “Setup WiFi Device” to enter the next step.
  2. If the device blue LED not light up, please check below config notes.
  3. Align the QR code on the phone with the camera lens to scan the code, and keep the distance between the phone and the camera 10cm.
  4. The connection is successful, press “OK” to complete the connection.

DEVICE SETTING

Notes about PIR detection
User can change the PIR detection sensitivity in device setings.we recommend to set sensitivity at “Disabled” or “Low” to reduce flase alret and save the battery power in noisy environments.

  • Disabled: disabled PIR detection. Low: deleay 7 seconds PIR detects a moving.
  • Medium: deleay 5 seconds PIR detects a moving.
  • High: deleay 1 second PIR detects a moving.

CONFIG NOTES

  1. Please charge the 18650 battery fully before using the device. The battery life will be affected by the device wake-up time and the number of wake-ups. Therefore, the PIR sensor alarm detection function is used in an environment with a lot of people. It is recommended to turn off or set the device to low sensitivity to reduce device wake-up and call times and extend battery life. When the battery is low, please charge the battery immediately.
  2. Keep the device in the range of your router.Make sure the device is placed close to the Wi-Fi router. If there has to be thick or insulated objects between the device and the Wi-Fi router, which may lead to weak Wi-Fi signal, please make sure the Wi-Fi signal is in good level before you start using the device.
  3. It is a delicate device with low power consumption design. Every time the device is awakened and will work for few seconds.After that, the device will enter standy mode to save power. Yu can set the work time in the app settings.
  4. Because mainland China does not receive Google’s system push messages, you need to open the app’s self-starting function in your phone to receive push messages.
  5. This device provides one month of free cloud storage services. If you need to continue using value-added services after the trial period expires, you need to purchase them in the app.
  6. Please insert 4G SIM card at first, then power on the camera. If the device red indicator is light always, then you can check the APN code on your mobilephone setting, then contact us to verify if the 4G signal of local telecom operator is match with the camera or not.