Makita DC18RD Two Port Multi Fast Charger Instruction Manual

makita DC18RD Two Port Multi Fast Charger

INTR9ODUCTION

WARNING:

THIS APPLIANCE CAN BE USED BY CHILDREN AGED FROM 8 YEARS AND ABOVE AND PERSONS WITH REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES OR LACK OF EXPERIENCE AND KNOWLEDGE IF THEY HAVE BEEN GIVEN SUPERVISION OR INSTRUCTION CONCERNING USE OF THE APPLIANCE IN A SAFE WAY AND UNDERSTAND THE HAZARDS INVOLVED. CHILDREN SHALL NOT PLAY WITH THE APPLIANCE. CLEANING AND USER MAINTENANCE SHALL NOT BE MADE BY CHILDREN WITHOUT SUPERVISION.

Symbols

  •  Indoor use only
  •  DOUBLE INSULATION
  • Charging
  •  Delay charge (Battery cooling or too cold battery
  • Conditioning
  •  Do not short batteries
  • Do not expose battery to water or rain
  •  Read instruction manual.
  •  Ready to charge
  •  Charging complete
  •  Deffective battery
  • Cooling abnormality
  • Do not destroy battery by fire.
  • Always recycle batteries.

Only for EU countries

Due to the presence of hazardous components in the equipment, waste electrical and electronic equipment, accumulators and batteries may have a negative impact on the environment and human health. Do not dispose of electrical and electronic appliances or batteries with household waste! In accordance with the European  Directive on waste electrical and electronic equipment and on accumulators and batteries and waste accumulators and batteries, as well as their adaptation to national law, waste electrical equipment, batteries and accumulators should be stored separately and delivered to a separate collection point for municipal waste, operating in accordance with the regulations on environmental protection. This is indicated by the symbol of the crossed-out wheeled bin placed on the equipment.

SAVE THESE INSTRUCTIONS

  • This manual contains important safety and operating instructions for battery charger.
  • Before using battery charger, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery.
  •  CAUTION – To reduce risk of injury, charge only Makita type rechargeable batteries. Other types of batteries may burst causing personal injury and damage.
  •  Non-rechargeable batteries cannot be charged with this battery charger.
  •  Use a power source with the voltage specified on the nameplate of the charger.
  •  Do not charge the battery cartridge in presence of flammable liquids or gases.
  •  Do not expose charger to rain or snow.
  •  Never carry charger by cord or yank it to disconnect from receptacle.
  • After charging or before attempting any maintenance or cleaning, unplug the charger from the power source. Pull by plug rather than cord whenever disconnecting charger.
  •  Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
  •  Do not operate charger with damaged cord or plug. If the cord or plug is damaged, ask Makita authorized service center to replace it in order to avoid a hazard.
  •  Do not operate or disassemble charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman. Incorrect use or reassembly may result in a risk of electric shock or fire.
  •  Do not charge battery cartridge when room temperature is BELOW 10°C (50°F) or ABOVE 40°C (104°F). At cold temperature, charging may not start.
  •  Do not attempt to use a step-up transformer, an engine generator or DC power receptacle.
  •  Do not allow anything to cover or clog the charger vents.

Charging for MAKITA batteries

  • This charger can charge two batteries at the same time.
  •  Plug the charger into the proper AC voltage source. Charging light will flash in green color repeatedly
  •  Insert the battery cartridge into charger until it stops adjusting to the guide of charger. Terminal cover of charger can be opened with inserting and closed with pulling out the battery cartridge
  •  When the battery cartridge is inserted, the red charging light will light up and charging will begin with a preset brief melody sound coming out for assurance as to which sound will come out to notify the completion of charging.
  •  With finish of charge, the charging light will change from red one to green one and the melody sound or buzzer sound (a long beep) comes out to notify completion of charge.
  •  Charging time varies by temperature (10°C (50°F) – 40°C (104°F)) that battery cartridge is charged at and conditions of the battery cartridge, such as a battery cartridge which is new or has not been used for a long period of time.
  •  After charging, remove the battery cartridge from charger and unplug the charger.

Changing melody sound of completed charging

  •  Insert the battery cartridge into the charging port that you want to change the melody sound of completed charging. It brings out the last preset brief melody sound of completed charging.
  •  Removing and re-inserting it within five seconds after this action makes the melody sound change.
  •  Every time removing and re-inserting it within another five seconds after this, the melody sound changes in order.
  •  When the desired melody sound comes out, leave the battery cartridge being inserted and the charge will begin. When a “short beep” mode is selected, no completed charging signals comes out. (Silent Mode)
  •  With finish of charge, the green light remains lit with the red light going out and the melody sound preset at the insertion of battery cartridge or buzzer sound (a long beep) comes out to notify completion of charge. (In selected silent mode, no sounds come out.)
  •  Preset melody sound remains stored even when the charger is unplugged.
    Voltage 9.6 V 12 V 14.4 V Capacity (Ah) Charging time (Minutes)
    Number of cells 8 10 12
     

     

    Ni-MH Battery cartridge

    		 B9017A — — 1.7 20
    BH9020/A — — 1.8 (IEC61951-2) 20
    — BH1220/C BH1420 1.8 (IEC61951-2) 15
    — — BH1427 2.5 (IEC61951-2) 20
    BH9033/A — — 3.1 (IEC61951-2) 30
    — BH1233/C BH1433 3.1 (IEC61951-2) 22
    Voltage 14.4 V 18 V 14.4 V 18 V Capacity (Ah) according to IEC61960 Charging time (Minutes)
    Number of cells 4 5 8 10
    BL1415 BL1815 — — 1.3 15
     

    —

    		  

    —

    		 BL1430/ BL1430A/ BL1430B BL1830/ BL1830B  

    3.0

    		  

    22

    BL1415N/ BL1815N — — 1.5 15
    BL1415NA
    Li-ion Battery — BL1820/ — — 2.0 24
    cartridge BL1820B
    — — BL1440 BL1840/ 4.0 36
    BL1840B
    — — BL1450 BL1850/ 5.0 45
    BL1850B
    — — BL1460A/ BL1860B 6.0 55
    BL1460B

    NOTE:

    •  The battery charger is for charging Makita-battery cartridge.
    • Never use it for other purposes or for other manufacturer’s batteries.
    •  When you charge a battery cartridge which is new or has not been used for a long period of time, it may not accept a fullcharge until after discharging it completely and recharging a couple of times. (Ni-MH battery only)
    •  If charging light may flash in red color, battery condition is as below and charging may not start.
    •  Battery cartridge from just-operated tool or battery cartridge that has been left in a location exposed to direct sunlight for a long time.
    •  Battery cartridge that has been left for a long time in a location exposed to cold air.
    • When the battery cartridge is too hot, charging will begin after
      the cooling fan installed in the charger cools the battery cartridge. Charging will begin after the battery cartridge temperature reaches the degree at which charging is possible.
    •  If the charging light flashes alternately in green and red color, charging is not possible.
    • The terminals on the charger or battery cartridge are clogged with dust or the battery cartridge is worn out or damaged.

    Cooling system

    •  This charger is equipped with a cooling fan for a heated battery in order to enable the battery to prove its own performance. Sound of cooling air comes out during cooling, which means no trouble on the charger.
    •  The yellow light will flash for a warning in the following cases.
    •  Trouble on the cooling fan
    •  Incomplete cool down of battery, such as, being clogged with dust
    • The battery can be charged in spite of the yellow warning light. But the charging time will be longer than usual in this case.
    • Check the sound of the cooling fan, vent on the charger and battery, which can be sometimes clogged with dust.
    •  The cooling system is in order although no sound of the cooling fan comes out if the yellow warning light will not flash.
    •  Always keep clean the vent on the charger and battery for cooling.
    •  The products should be sent to repair or maintenance if the yellow warning light will frequently flash.

    Conditioning charge

    Conditioning charge can extend the life of the battery by automatically searching the optimum charging condition for the batteries in every situation. The battery employed in the following conditions repeatedly requires a “conditioning charge” to prevent fast wear out. In that case, yellow light lights up.

    •  Recharge of battery with its high temperature
    •  Recharge of battery with its low temperature
    •  Recharge of full charged battery
    •  Over-discharge of battery (continue to discharge the battery in spite of down of power.)
    • The charging time of such a battery is longer than usual.

    Using with a USB device (Country specific)

    • This charger works as an external power supply for USB devices.
    •  Open the cover of the USB power supply port. Connect the
    • USB cable to the USB power supply port and USB device.
    •  Plug the charger into a power source.
    •  After charging, unplug the charger.

    CAUTION:
    Do not insert a nail, wire, etc. into the USB power supply port.

    Note:

    •  Before connecting a USB device to the charger, always backup your data of the USB device. Otherwise, your data may lose by any possibility.
    •  The charger may not supply power to some USB devices.
    •  When not using or after charging, remove the USB cable and close the cover.

    OVERVIEW

    1.  USB power supply port
    2.  Cover
    3.  USB cable