Bosch HEZ638D10 Dishwasher Instruction Manual

BOSCH HEZ638D10 Dishwasher

Detaching and refitting the rails

Risk of burns!
The rails become very hot. Never touch the hot rails. Always allow the appliance to cool down. Keep children away from the appliance.

Detaching the rails
  1. Raise the front of the rail a little a and detach it b (fig. ).
  2. Then pull the whole rail to the front and remove it (figure ).
Hooking in the rails

The rails only fit on the right or the left side. The pull-out rails must pull out towards the front.

  1. First, insert the rail in the centre of the rear socket a until the rail lies against the wall of the cooking compartment, and push it towards the back b (fig. ).
  2. Then insert it into the front socket C until the rail also lies against the wall of the cooking compartment here, and push it downwards d (fig. ).

Note: Depending on the pull-out system, you must change the basic settings on your appliance. To do this, refer to the “Basic settings” section in the instructions for use.

Cleaning

Rails Hot soapy water:
Soak and clean with a dish cloth or brush.
Pull-out system Hot soapy water:
Clean with a dish cloth or a brush.
Do not remove the lubricant while the pull out rails are pulled out – it is best to clean them when they are pushed in. Do not clean in the dishwasher.