Canon 322 Cyan Toner Cartridge User Manual
User Manual
This is Limited modular approval as this module is limited to installation by the grantee into our host systems
This Wireless LAN Module is not sold to general end-users directly.
For the details about this module, please refer to the specification sheet for the module.
This module should be installed in the host device according to the interface specification (installation manual).
This device complies with part 15 of the FCC Rules.
Part 15 Subpart C
The end product must be labeled “Contains FCC ID: AZD322/ IC: 498J-322”
The following statement must be included in the user manual of the host device.
FCC/IC Notice
Model: CD1171 (including WLAN Module Model WM322, FCC ID: AZD322 / IC: 498J-322)
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment should be installed and operated keeping the radiator at least 20cm or more away from the person’s body.
This device complies with Part 15 of FCC Rules and ISED’s applicable license-exempt RSSs. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If such changes or modifications should be made, you could be required to stop the operation of the equipment.
The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed on the grant (FCC Part 15.247), and the host product manufacturer is responsible for compliance with any other FCC rules that apply to the host not covered by the modular transmitter grant of certification.
The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed. The following statements shall be described after confirming that the end product complies with FCC Part 15B.
FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions;
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The cable with the ferrite core provided with the printer must be used with this equipment in order to comply with Class B limits in Subpart B of Part 15 of the FCC rules.
Canon U.S.A., Inc.
One Canon Park, Melville, New York 11747, U.S.A.
Tel No. 1-800-OK-CANON (1-800-652-2666)
Canadian Radio Interference Regulations
CAN ICES-3 (B)/NMB-3 (B)