Sony YY2950 Bluetooth Earbuds User Manual

SONY YY2950 Bluetooth Earbuds User Manual

Charging the headset

  1. Set the headset into the charging case.
  2. Connect the charging case to an AC outlet. Use the supplied USB Type-C cable and a commercially available USB AC adaptor. The indicator (orange) on the charging case lights up. and charging starts on the headset and the charging case.
    When charging of the headset and the charging case is complete. the indicator (orange) on the charging case turns off automatically. Remove the USB Type-C cable.

Wearing the headset

  1. Hold the headset with your fingers.
  2. Twist the headset unit to fit it snugly into the ear canal. and adjust the positioning of the headset unit until it fits comfortably.

Pairing and connecting to Bluetooth devices

  1. Put the headset into the charging case.
  2. Open the cover of the case, then hold the Pairing button on the cover for 5 seconds. The LED on the charging case flashes blue.
  3. Remove the headset from the case and wear it.
  4. Set Bluetooth function to ON on your Android smartphone/iPhone.
  5. Touch [YY2950]
    You will hear the voice guidance say, “Bluetooth connected”, from both headset units.

Listening to music via a Bluetooth connection

  1. Wear the headset.
  2. Operate the touch sensor of the headset.
Tap the touch sensor on the right once
Tap the touch sensor on the right twice
Operate the Bluetooth device to start playback and adjust the volume to a moderate level.

Receiving a call

  1. Connect the headset to a smartphone or mobile phone via Bluetooth connection beforehand.
  2. When you hear a ring tone, tap the touch sensor on the left or right unit of the headset twice (with an interval of about 0.3 seconds) and receive the call.
  3. When you finish talking. tap the touch sensor on the left or right unit of the headset twice (with an interval of about 0.3 seconds) to end the call.

To reject a call
When you hear a ring tone. hold your finger to the touch sensor for about 2 seconds.

Using the voice assist function

  1. Put the headset units into your ears and connect the headset to the smartphone via Bluetooth connection.
  2. Hold your finger to the touch sensor on the right unit for about 2 seconds. The voice command is canceled when a certain time has passed without requests.