Bosch B36CD50SNS French Door Counter-Depth Smart Refrigerator Instructions

B36CD50SNS French Door Counter-Depth Smart Refrigerator
Instruction Manual

Assembly instructions
Available from our Customer Service

IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS

Observe the following safety instructions.
Risk of injury
WARNING
The high weight of the appliance may result in injury when lifted.
▶ Do not lift the appliance on your own.

Risk of electric shock
WARNING
Improper installations are dangerous.

  • Connect and operate the appliance only in accordance with the specifications on the rating plate.
  • Connect the appliance to a power supply with alternating current only via a correctly installed socket outlet with grounding.
  • The protective conductor system of the domestic electrical installation must be properly installed.
  • Never equip the appliance with an external switching device, e.g. a timer or remote control.
  • When the appliance is installed, the power plug of the power cord must be freely accessible. If free access is not possible, an all-pole isolating switch must be integrated in the permanent electrical installation according to the installation regulations.
  • When installing the appliance, check that the power cord is not trapped or damaged.

If the insulation of the power cord is damaged, that can be dangerous.

  • Never let the power cord come into contact with heat sources.

Risk of explosion
WARNING
If the appliance’s ventilation openings are sealed, a leak in the refrigeration circuit may result in a flammable mixture of gas and air.

  • Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.

Risk of fire
WARNING
It is dangerous to use an extended power cord and non-approved adapters.

  • Do not use extension cords or multiple socket strips.
  • If the power cord is too short, contact customer service.
  • Only use adapters approved by the manufacturer.

Portable multiple socket strips or portable power supply units may overheat and cause a fire.

  • Do not place portable multiple socket strips or power supply units on the back of the appliance.

Preventing material damage

NOTICE:
The high weight of the appliance may damage the floor when it is moved.

  • Use a hand-cart and floor protection when moving the appliance.
    When the appliance door is closed, the mullion rail should be closed (flush with the door edge) or damage may occur.
  • Never open the mullion rail manually.
  • If the mullion rail has been opened, rotate it closed (flush with the door edge) before closing the appliance door.
    Using the base, runners, or appliance doors as a seat or climbing surface may damage the appliance.
  • Do not stand or lean on the base, runners, or doors.
    If the water pressure is too high or too low, this may impair the functioning of the appliance.
  • Make sure that the water pressure in the water supply system is at least 29 psi (200 kPa) and max. 116 psi (800 kPa).
    Modified or damaged water hoses may result in material damage and damage to the appliance.
  • Never kink, crush, modify or cut through water hoses.
  • Never re-use water hoses that have been used before.
  • Never pull on the water hose on the rear panel of the appliance.