Marvel MLCP215-IS01B Undercounter Refrigeration Owner’s Manual

MARVEL MLCP215-IS01B Undercounter Refrigeration

Welcome to the Marvel Experience!

Congratulations on your purchase of the industry’s quietest clear ice machine with the best ice clarity and purity. Your new investment is protected by a limited warranty for the first year, and hermetically sealed refrigeration system parts are covered for an additional 4 years. Here’s your guide to the operation and maintenance of your= Marvel Clear Ice Machine to ensure years of enjoyment. If you have any questions, please contact Marvel Customer Service or Tech Support at:

Got a Marvelous Design?

We would love to see how your Marvel product looks in its new home. Send us photos at [email protected], and we might feature your Marvel home design on our website and social media!

Warranty Registration

It is important you send in your warranty registration card immediately after taking delivery of your appliance or you can register online at www.marvelrefrigeration.com.
The following information will be required when registering your appliance:
Service Number
Serial Number
Date of Purchase
Dealer’s name and address
The service number and serial number can be found on the serial plate which is located inside the cabinet on the left side near the top.

INTEGRATED PANEL DIMENSIONS

INTEGRATED PANEL INSTALLATION

Panel Installation

  • 3/4″ (20 mm) panel
  • 14%” (379 mm) width
  • 30″ (762 mm) height
  1. Fully open door.
  2. Starting at a corner, pull the gasket away from the door.
  3. Continue to pull the gasket free from the gasket channel.
  4. Upon removal, lay the gasket down on a flat surface.
  5. Align the top of the panel with the top edge of the door. Center panel on the door.
    NOTE: Due to differences in floor construction or surrounding cabinetry, the panel may not sit flush with the top of the door.
  6. Secure integrated panel to door using clamps. A robust tape may also be used. Marvel recommends the use bar clamps to secure the panel to the door. If using tape, be certain the tape will not damage the panel finish upon removal.
  7. Using a 7/64″ (3 mm) drill bit, drill 6 pint holes into the wood panel 1/2″ (12 mm) deep using the holes in the door frame as a guide.
    NOTE
    It is important to ensure that all drilled holes are drilled to the correct depth in order to avoid splits in the wood when hardwood is installed.
  8. Locate 6 of the #6x 1-1/2″ (38 mm) screws provided with your unit.
  9. Using a Phillips Screwdriver, place one screw into each of the 6 pilot holes and screw down. Do not over-tighten screws.
  10. Ensure the screws sit flush against the bottom of the channel.
  11. Remove clamps from the door.
    NOTE
    If the panel requires additional adjustment after removing clamps, slightly loosen each screw and adjust the panel as necessary. Tighten screws upon completion.
  12. Starting at the corners, re-install the gasket into the gasket channel in the frame. Make sure the gasket is fully seated.