Philips PPA1002 Android TV Remote Control product User Guide
PHILIPS PPA1002 Android TV Remote Control product 
Box content
Please open the package and check the following accessories:
- Remote Control
- Quick start guide
Overview
Instructions
- Indicator Light: Press any key and the indicator light flashes
[Note] The indicator light will flash quickly when the remote batteries are low. Please replace the batteries. - Bluetooth Pairing: Pressed the “OK” and “Volume-” keys together on your Remote Control for 10 seconds
Product specification
- Product is powered by dry battery, Battery specifications AAA 1.5*2
- Operating temperature 0～50℃
FCC Caution
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement
- This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
- This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Screeneo Innovation SA
Route de Lully 5C
1131 – Tolochenaz – Switzerland
www.philips.com/welcome
[email protected]
FCC: 2ASRT-PPA1002
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. used under license. Screeneo Innovation SA is the warrantor in relation to the product with which this booklet was packaged.
2020 © Screeneo Innovation SA All right reserved