Cisco IG21 Industrial Gateway Installation Guide

IG21 Industrial Gateway
Installation Guide

IG21, IG21R, and IG31R Hardware 

FCC and ISED Interference Statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. For products available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance 20cm between the radiator and your body. This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation.

This radio transmitter [IG21 IC: 2461N-IG21; IG31R IC: 2461N-IG31R ] has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited from use with this device.

Antenna type Model Number Antenna Gain (dBi)
Dipole IG21 4.
Dipole IG31R TBD

IG21, IG21R, and IG31R Hardware Installation Guide
FCC and ISED Interference Statement

Antenna type Model Number Antenna Gain (dBi)
Dipole IG21R 4.
Dingle TC711R TAT)

IMPORTANT NOTE:
ISED Radiation Exposure Statement:
This equipment complies with ISED RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. The transmitter module may not be co-located with any other transmitter or antenna.
CAN ICES-3 (A)/NMB-3(A)
The Country Code Selection feature is disabled for products marketed in the US/Canada For products available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible.