HP NS1 Bluetooth Speaker User Guide
hp NS1 Bluetooth Speaker
OVERVIEW
- Power button
Turns the speaker on or off. The first time you turn on the speaker, it automatically enters Bluetooth® pairing mode. To connect to a device through Bluetooth, see the device documentation. The speaker turns off after 5 min if you do not pair it to a device or connect it to a device through an auxiliary cable (not included). Press and hold the button for 3 s to enter pairing mode and either pair to a new device or connect to the last paired device. The speaker remembers up to 8 connected devices. - Volume down button
Decreases the volume. Press and hold to play the previous track. During a phone call, press and hold to mute your microphone. - Power light
White: The speaker is on and connected to a device. Blinking white: The speaker is in pairing mode. Amber: The speaker is charging. Blinking amber: The battery charge level is less than 20%. A low battery tone plays with increasing frequency. - Volume up button
Increases the volume. Press and hold to play the next track. During a phone call, press and hold to switch between two calls. - Call button
Answers a call. If connected to a device through Bluetooth, pauses your audio when pressed. Press again to answer a second call. Press and hold to end or decline a call and return to your previous call or audio. - USB Type-C® port
Connects the speaker to power. Fully charge the speaker before first use. - Audio-in jack
Connects the speaker to a device. - Lanyard attachment point
Attach a lanyard (not included) to the speaker. Product passed IP54 testing for protection against dust ingress and water splashes. To maintain the IP54 rating, close the I/O door. IP ratings are not a guarantee of future performance. Cable not included.
HOW TO USE
Was this manual helpful?
Thank you for your feedback!