HP Bluetooth Speaker 350 User Manual

HP Bluetooth Speaker 350

Power button

Turns the speaker on or off. The first time you turn on the speaker, it automatically enters Bluetooth pairing mode. To connect to a device through Bluetooth, see the device documentation. The speaker turns off after 5 min if you do not pair it to a device or connect it to a device through an auxiliary cable (not included). Press and hold the button for 3 s to enter pairing mode and either pair to a new device or connect to the last paired device. The speaker remembers up to 8 connected devices.

Volume down button

Decreases the volume. Press and hold to play the previous track. During a phone cll, press and hold to mute your microphone.

Volume up button

Increases the volume. Press and hold to play the next track. During a phone call, press and hold to switch between two calls.

Call button

Answers a call. If connected to a device through Bluetooth, pauses your audio when pressed. Press again to answer a second cll. Press and hold to end or decline a call and return to your previous call or audio.

Power light

white: The speaker is on and connected to a device. Blinking white: The speaker is in pairing modeAmber: The speaker Is Charging Blinking amber: The battery charge level is less than 20%. A low battery tone plays with increasing frequency.

Audio-in jack

Connects the speaker to a device.

USB Type-C°port

Connects the speaker to power EFully charge the speaker before first use.

Lanyard attachment point

Attach a lanyard (not included) to the speaker. The product passed IP54 testing for protection against dust ingress and water splashes. To maintain the lP54 rating. close the l/0 door. IP ratings are not a guarantee of future performance. Cable not included.