Daewoo FLR00044 Tornado Cordless 2in1 Vacuum Cleaner User Manual

FLR00044 Tornado Cordless 2in1 Vacuum Cleaner
User Manual

Tornado Cordless 2in1 Vacuum FLR00044

TORNADO FREEDOM
120W CORDLESS 2 IN I VACUUM UPRIGHT AND HANDHELD
‘Please refer to me warranty section for terms of your extended guarantee

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be followed. These instructions should be saved for future reference:

  • Read and familiarise yourself with all operating instructions before using this Vacuum Cleaner.
  • Before plugging your unit into the mains, visually check that the unit is intact and has not suffered any transit damage.
  • Check that the voltage indicated on the data plate corresponds with that of the local network before connecting the appliance to the main power supply.
  • This appliance can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
  • Children shall not play with the appliance.
  • Keep the appliance and its cord out of reach of children less than 8 years when it is energized or cooling down.
  • Do not immerse the appliance or its cord/charger in water or any other liquids.
  • Do not leave the appliance unattended during use.
  • Do not leave the appliance unattended whilst connected to the main supply.
  • Do not use this appliance outdoors.
  • It is imperative to unplug the power cord/charger after charging before it is cleaned and whilst being repaired.
  • Repairs to electrical appliances should only be performed by a qualified electrician. Improper repairs may place users at serious risk.
  • Do not operate this appliance with a damaged plug or cord, after a malfunction, or after being dropped or damaged in any way.
  • Regular, periodic checks should be carried out on the main cable to ensure no damage is evident. Should there be any signs of damage the appliance should not be used.
  • If the power cable is damaged, it should only be replaced by the manufacturer or a suitably qualified after-sales-service in order to avoid a hazard
  • Allow the unit to cool before storage.
  • Before cleaning, disconnect the appliance from the mains supply and allow to cool.
  • This appliance is intended for household use only and should not be used for industrial purposes.
  • Do not use any accessories or attachments with this appliance other than those supplied or recommended by the supplier.
  • Do not use this appliance for anything other than its intended use.
  • Do not push objects into any openings as damage to the appliance and/or electric shock may occur.
  • Unplug after each use. Grasp the plug, not the cord.
  • Do not pull or carry the Vacuum Cleaner by the electrical cord, use the handles provided.
  • Ensure fingers and other objects are never placed in any part of the vacuum cleaner. Clothing or hair may become trapped if the vacuum is used improperly.
  • Keep hair, loose clothing, jewelry, fingers, and all parts of the body away from openings and moving parts.
  • Keep all air vents clear and free of dust, lint, hair and anything else that may reduce airflow.
  • Avoid directing the appliance towards naked flames as the air discharged may extinguish gas fires or pilot lights and may disturb ashes in open fires.

Description of parts

 

  1. Upright vacuum ON/OFF switch.
  2. Speed button
  3. Handheld vacuum release button.
  4. Handheld vacuum ON/OFFswitch
  5. ON/OFF/charge level indicator
  6. Dust cylinder release button.
  7. Upright brush head.
  8. LED light
  9. Brush release button.
  10. Crevice tool.
  11. Charging dock.
  12. Charging mount.
  13. Upholstery tool.
  14. Power supply.

Assembly

  1. Fit the handle onto the main body of the vacuum and secure into place by fixing the screw provided into the hole at the rear of the handle.
  2. Fit the main body of the vacuum onto the brush head and push home until it clicks into place, then fix the two screws provided into the holes at the rear of the main body.

Using the handheld vacuum cleaner
Detach the handheld unit from the main body by pressing the handheld vacuum release button (3) and tilting the handheld unit away from the main body.
To operate the handheld vacuum, use the handheld vacuum ON/OFF switch (4).
The crevice tool or upholstery tool can be attached to the handheld unit to clean hard-to-reach places and for cleaning soft furnishings.
Using the upright vacuum cleaner
In the upright mode, the vacuum cleaner can be used to clean carpets and hard floors.
To operate the vacuum in the upright mode, use the upright vacuum ON/ OFF switch (1), the suction and brush speed can be selected using the speed button (2). The brush assembly has a stall protection system. If the brush becomes fouled with excess fiber/string etc, the brush motor will automatically stop.
When the vacuum is in use, in either mode, the ON/OFF charge level indicator (5) will illuminate.
This indicator shows the level of charge left in the battery from three to one light.

Charging

  1.  Plug the power supply jack into the rear of the charging dock and the plug into a suitable socket outlet.
  2. Mount the vacuum on the base by aligning the vacuum with the charging mount (12) on the charging dock (11) and allow to drop into place.
  3. The vacuum will now start to charge.
  4. When all three lights on the ON/OFF charge indicator are lit, the vacuum is fully charged.

Cleaning and maintenance

To empty the dust cylinder, remove the handheld unit from the main body and press the dust cylinder release button (6), then tilt the dust cylinder forward, separating it from the handheld unit motor section. Remove the filter from the dust cylinder and empty the cylinder. Clean the filter by tapping it lightly over a dustbin.
Always disconnect the vacuum charging base from the mains power supply before cleaning. Wipe clean the outside of the vacuum and charging base with a soft damp cloth. Never clean any part of the vacuum or charging base with harsh or abrasive cleaners. Do not submerge any part of the charging base, power supply, or vacuum in water or any other liquids.

Technical Data

Power pack Li-ion battery 22.2V (6×3.7V cells)
Battery Capacity 2200mAh
Running time 20 mins (high speed), 40 mins (low speed)
Power 120W
Power supply
Input 100-240V 50Hz, 0.5A, 120.0W
Output 27.0V DC, 500mA

Customer Support
Should you require any product information, replacement parts or accessories, please contact our customer care team at or call 0161 831 7879.

  • Replacement parts and accessories are guaranteed for 1 year from the date of purchase.
  • It is important to note that your warranty becomes invalid should non-Daewoo parts or accessories be used with this appliance

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice.
Waste batteries should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice.

Troubleshooting guide

Problem Possible reason Solution
Motor does not operate Battery is low on power The hand held vacuum is not fitted to the main body. (Power to the brush head is supplied from the battery in the handheld unit) Charge the battery Correctly fit the handheld unit to the main body of the vacuum
Suction is reduced Dust cylinder is full Filter is clogged The air duct to the upright brush head is blocked Battery is low Empty the dust cylinder Clean or replace the filter
Clear the debris from the air duct Fully charge the
battery
Charge indicator does not light up The handheld unit is not fitted to the main body Properly fit the handheld unit to the main body of the vacuum cleaner
Operating time is reduced The battery has not been fully charged The battery is aging Fully charge the battery as indicated in the charging section of this manual Batteries will deteriorate over time, new batteries should only be fitted by qualified service personel

WARRANTY

Thank you for purchasing your Daewoo Vacuum

As part of our commitment to quality we are offering you an extra 2 years warranty in addition to your 1 year guarantee.Your Daewoo vacuum product is guaranteed for 1 year from the date of original purchase, with proof of purchase or receipt. If any defects should arise due to faulty workmanship or material, your faulty vacuum should be returned  o the place of purchase, replacement or refund is at the discretion of the retailer.
The guarantee is subject to the following provisions:

  • The product must be correctly installed and operated in accordance with the requirements contained in the instruction manual.
  • The product must be used solely for domestic purposes.
  • It does not cover general wear and tear, damage, misuse or any consumable parts.
  • The Guarantee is rendered invalid if the product has been resold or has been damaged through inexpert repair.
  • The guarantee is only valid within the UK and Eire.

Your standard 1 year guarantee will only be extended to the maximum available for your individual product upon registration. (Note: products must be registered  dividually  nd covers the main body and housing) If you do not register your product within 28 days of the original purchase date, your product will only be guaranteed for year.
To validate your extended 2 year warranty* please register your purchase online within 28 days of the original purchase date by registering at www.daewoowarrantyregistration.com/warranty-registration
*Your extended warranty is only valid with proof of purchase receipt and subject to the conditions outlined above.

ESG Ltd
Manchester M3 1JS
www.esgltd.com

Daewoo® is a registered trademark.
Produced and imported under licence by ESG Ltd