HP pDHSAP011D Wireless Dongle User Manual

HP pDHSAP011D Wireless Dongle

Safety Notices

  • Do not allow the AC adapter to contact the skin or a soft surface, such as pillows or rugs or clothing, during operation. The AC adapter complies with the user-accessible surface temperature limits defined by applicable safety standards.
  • To reduce the risk of electric shock or damage to the equipment:
  • Plug the AC adapter into an AC outlet that is easily accessible at all times.
  • It the power cord has a 3-pin attachment head, plug the cord into a grounded (earthed) 3-pin outlet.

Laser compliance

  • Some products may contain a laser that is classified as a Class 1 Laser Product in accordance with US FDA regulations and the IEC 60825-1.
  • Each laser product complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007 or Laser Notice No. 56, dated May 8, 2019; and with IEC 60825-1:2007.
  • WARNING! Use of controls or adjustments or performance of procedures other than those specified herein or in the laser product’s installation guide may result in hazardous radiation exposure.
  • To reduce the risk of exposure to hazardous radiation:
  • Do not try to open the module enclosure. There are no user-serviceable components inside.
  • Do not operate controls, make adjustments, or perform procedures to the laser device other than those specified herein.
  • Allow only HP Authorized service technicians to repair the unit.

Power cord notice
If you were not provided with a power cord for the computer or for an external power accessory intended for use with the computer, you should purchase a power cord that is approved for use in your

Country or region.
The power cord must be rated for the product and for the voltage and current marked on the product’s electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and current rating marked on the product. In addition, the diameter of the wire must be a minimum of 0.75 mm2/18AWG, and the length of the cord must be between 1.0 m (3.2 ft) and 2 m (6.56 ft). If you have questions about the type of power cord to use, contact your authorized service provider. A power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or against it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord exits from the product.

Singapore wireless notice

Turn off any WWAN devices while you are onboard aircraft. The use of these devices onboard aircraft is illegal, may be dangerous to the operation of the aircraft and may disrupt the cellular network. Failure to observe this instruction may lead to suspension or denial of cellular services to the offender, or legal action, or both. Users are reminded to restrict the use of radio equipment in fuel depots, chemical plants, and where blasting operations are in progress. As with other mobile radio transmitting equipment, users are advised that for satisfactory operation of the equipment and for the safety of personnel, no part of the human body should be allowed to come too close to the antennas during operation of the equipment. This device has been designed to comply with applicable requirements for exposure to radio waves, based on scientific guidelines that include margins intended to assure the safety of all people, regardless of health and age. These radio wave exposure guidelines employ a unit of measurement known as the speciñic absorption rate (SAR). Tests for SAR are conducted using standardized methods, with the phone transmitting at its highest certified power level in all used frequency bands.The SAR data information is based on CENELEC’s standards EN50360 and ENSO361, which use the limit of 2 watts per kilogram, averaged Over 10 grams of tissue.

Headset and earphone volume level notice
To prevent possible hearing damage, do not use high volume levels for long periods. Before using a headset or earphones, always reset the volume to a low level. For your own safety, use headsets or earphones compliant with the headphone limits in EN 50332-2. When the HP product includes a headset or earphones, the combination is in compliance to EN 50332-1.

Battery Section

  • User-replaceable battery notices
  • When a battery has reached the end of its useful life, do not dispose of the battery in general household waste. Follow the local laws and regulations in your area for computer battery disposal
  • HP encourages customers to recydle used electronic hardware,
  • HP original print cartridges packaging, and rechargeable bat teries.
  • For more information about recydling programs, refer to the HP website at http://www.hp.com/recycle
  • For information about removing a user-replaceable battery. refer to the user guide included with the product.
  • WARNING! Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions
  • WARNING! To reduce therisk of fire ar burns, do not disassemble, crush, or puncture; do not short external contacts; do not dispose of in fire or water.
  • WARNING! Keep the battery away from children.
  • WARNING! To reduce potential safety issues, only the G battery provided with the computer, a replacement battery provided by HP, or a compatible battery purchased as an accessory from HP should be used with the computer.

Information for European Union CommissionRegulation 1275/2008
To locate product power consumption data, including when the product is in networked standby with all wired network ports connected and wireless devices connected, refer to section P14 “Additional information” of the product IT ECO Declaration at http://www.hp.com/hpinfo/globalcitizenship/environment/productdata/itecodesktop-pc.htm Where applicable, activate and deactivate a wireless network using the instructions included in the product user guide or the operating system. Information is also available at http://www.hp.com/support

India’s restriction of hazardous substances (RoHS)
This product, as well as its related consumables and spares, complies with the reduction in hazardous substances provisions of the “India E-waste Rule 2016.” It does not contain lead, mercury, hexavalent chromium, polybrominated biphenyls or polybrominated diphenyl ethers in concentrations exceeding 0.1 weight % and 0.01 weight % for cadmium, except where allowed pursuant to the exemptions set in Schedule 2 of the Rule.