Asus Rog Falchion M601 Wireless Mechanical Gaming Keyboard User Guide

ASUS Rog Falchion M601 Wireless Mechanical Gaming Keyboard

Getting started

  1. Connect the bundled Type-C® cable to your keyboard.
  2. Connect your keyboard to the PC.
  3. Download and install the Armoury Crate software from
    https://www.asus.com/supportonly/Armoury%20Crate/HelpDesk_Download/
  4. Follow the software instructions to update your keyboard’s firmware.
  5. Customize your keyboard using Armoury Crate.

Setting up a wireless keyboard

  1. Remove the wireless dongle from the keyboard.
  2. Insert the wireless dongle to a USB port on the PC.
  3. Set the power switch to ON.

Battery Status

The RGB indicator on your gaming keyboard will turn red (breathing) and the LEDs for all the other keys will switch off when the battery power is below 20% in wireless mode. You may charge your gaming keyboard by using the bundled USB cable.

Key combinations

Default Profiles

On-the-fly Macro Recording

Function Lock

RED RF Output table

Federal Communications Commission Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  • This device may not cause harmful interference.
  • This device must accept any interference received including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with manufacturer’s instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

CAUTION! The use of shielded cables for connection of the monitor to the graphics card is required to assure compliance with FCC regulations. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

RF exposure warning
The equipment complies with FCC RF exposure limits set forth for an uncontrolled environment.
The equipment must not be co-located or operating in conjunction with any other antenna or transmitter.