Honeywell RC-UV-1 Remote Control User Manual

Honeywell RC-UV-1 Remote Control

Operating

  1. Press the power off button, the UVC lamp will be off in standby state and the indicator light will always be on.
  2. Press the power button, and the UVC lamp indicator light will flash slowly for 60 seconds. After 60 seconds, the UVC lamp will work.
  3. Press the timing button “15min,30min,60min”. After the indicator light flashes slowly for 60 seconds, the UVC lamp will start and start the timing.

FCC Warning

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation.

NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

 

NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
RF Exposure:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.