Hoover HOT1151B 60cm Built-In Oven Instruction Manual

HOOVER HOT1151B 60cm Built-In Oven

 

Safety Indications

  • During cooking, moisture may condense inside the oven cavity or on the glass of the door. This is a normal condition.
  • To reduce this effect, wait 10-15 minutes after turning on the power before putting food inside the oven. In any case, the condensation disappears when the oven reaches the cooking temperature.
  • Cook the vegetables in a container with a lid instead of an open tray Avoid leaving food inside the oven after cooking for more than 15/20 minutes

WARNING

  • the appliance and accessible parts become hot during use. Be careful not to touch any hot parts.
  • the accessible parts can become hot when the grill is in use. Children should be kept at a safe distance and ensure that the appliance is switched off before replacing the bulb, to avoid the possibility of electric shocks.
  • in order to avoid any danger caused by the accidental resetting of the thermal interruption device, the appliance should not be powered by an external switching device, such as a timer, or be connected to a circuit that is regularly switched on and off
  • Children under 8 should be kept at a safe distance from the appliance if not continuously supervised.
  • Children should not play with the appliance.
  • The appliance can be used by those aged 8 or over and by those with limited physical, sensorial or mental capacities, without experience or] knowledge of the product, only if supervised or provided with instruction as to the operation of the appliance, in a safe way with awareness of the possible risks.
  • Cleaning and maintenance should not be carried out by unsupervised children.
  • Do not use rough or abrasive materials or sharp metal scrapers to clean the oven door glasses, as they can scratch the surface and cause the glass to shatter.
  • The oven must be switched off before removing the removable parts
  • After cleaning, reassemble them according to the instructions.
  • Only use of the meat probe is recommended for this oven.
  • Do not use a steam cleaner for cleaning operations.
    Connect a plug to the supply cable that is able to bear the voltage current and load indicated on the tag and have the earth contact. The socket must be suitable for the load indicated on the tag and must have ground contact connected and in operation.
  • The earth conductor is yellow-green in color This operation should be carried out by a suitably qualified professional. In case of incompatibility between the socket and the appliance plug, ask a qualified electrician to substitute the socket with another suitable type. The plug and the socket must be conformed to the current norms of the installation country.
  • Connection to the power source can also be made by placing an omnipolar breaker between the appliance and the power source that can bear the maximum connected load and that is in line with current legislation
  • The yellow-green earth cable should not be interrupted by the breaker.
  • The socket or omnipolar breaker used for the connection should be easily accessible when the appliance is installed.
  • The disconnection may be achieved by having the plug accessible or by incorporating a switch in the fixed wiring in accordance with the wiring rules it the power cable is damaged, it should be substituted with a cable or special bundle available from the manufacturer or by contacting the customer service department. The type of power cable must be
  • HOSV2V2-F This operation should be carried out by a suitably qualified professional. The earth conductor (yellow-green) must be approximately 10 mm longer than the other conductors. For any repairs, refer only to the Customer Care Department and request the use of original spare parts.
  • Failure to comply with the above can compromise the safety of the appliance and invalidate the guarantee.
  • Any excess of spilled material should be removed before cleaning
  • A long power supply failure during an occurring cooking phase may cause a malfunction of the monitor. In this case contact customer service
  • The appliance must not be installed behind a decorative door in order to avoid overheating.
  • When you place the shelf inside, make sure that the stop is directed upwards and in the back of the cavity. The shelf must be inserted completely into the cavity.
  • WARNING: Do not line the oven walls with aluminum foil or single-use protection available from stores. Aluminum foil or any other protection, in direct contact with the hot enamel, risks melting and deteriorating the enamel of the insides.
  • Never remove the oven door seal
  • CAUTION: Do not refill the cavity bottom with water during cooking or when the oven is hot.
  • No additional operation/setting is required in order to operate the appliance at the rated frequencies.

General Instructions

We thank you for choosing one of our products, For the best results with your oven, you should read this manual carefully and retain it for future reference. Before installing the oven, take note of the serial number so that you can give it to the customer service staff f any repairs are required. Having removed the oven from its packaging. check that it has not been damaged during transportation. if you have doubts, do not use the oven and refer to a qualified technician for advice. Keep all of the packaging material (plastic bags, polystyrene, nails) out of the reach of children When the oven s switched on for the first time, strong heating for the first time. This is absolutely normal and, if it occurs, you should wait for the smoke to dissipate before putting Food in the oven. The manufacturer accepts no responsibility in cases where the instructions contained in this document are not observed

NOTE: the oven functions, properties, and accessories cited in this manual will vary, depending on the miodel you have purchased

Safety Indications

Only use the oven for its intended purpose, that is only for the cooking of foods; any other use, for For example, as a heat source, is considered improper and therefore dangerous. The manufacturer cannot be held responsible for any damage resulting from improper, incorrect or unreasonable usage The use of any electrical appliances implies the observance of some fundamental rules

  • Do not pull on the power cable to disconnect the plug from the socket:
  • Do not touch the appliance with wet or damp hands or feet
  • In general, the use of adaptors, multiple sockets, and extension tables is not recommended:
  • In case of malfunction and/or poor operation, switch off the appliance and do not tamper with it.

Electrical Safety

ENSURE THAT AN ELECTRICIAN OR QUALIFIED TECHNICIAN MAKES THE ELECTRICAL CONNECTION

The power supply to which the oven s connected must conform with the laws in force in the country installation. The manufacturer accepts responsibility for any damage caused by thefailure to observe these itstructions. The oven must be connected to an electrical supply with an earthed wall outlet or a disconnector with multiple poles, depending on the laws in force in the country of installation. The electrical supply should be protected with suitable fuses and the cables used must have a transverse sectio that can ensure the correct supply to the oven.

CONNECTION

The oven is supplied with a power cable that should only be connected to an electrical supply with 220 240 Vac power between the phases or between the phase and neutral, Before the oven is connected to the electrical supply, it is important to check: the power voltage indicated on the gauge: the setting of the disconnect The grounding wire connected to the oven’s earth terminal must be connected to the earth terminal of the Power Supply

WARNING

Before connecting the oven to the power supply, ask a qualified electrician to check the continuity of the power supply earth terminal. 1he manufacturer accepts no responsibility for any accidents or other problems caused by failure to connect the oven to the earth terminal or by an earth connection that has defects in continuity.

NOTE: as the oven cOuld require maintenance work, It is advisable to keep another wall socket available so that the oven can be connected to this if it is removed from the space in which it is installed. The power cable must only be substituted by technical service staff or by technicians with equivalent qualifications. A low light around the central main switch could be present when the oven is off This s normal behavior. can be removed just by turning the plug Upside down or swapping the supply terminals:

Recommendations

After each use of the oven, a minimum of cleaning will help keep the oven perfectly clean Do not line the oven walls with aluminum foil or single-use protection available from stores Aluminium foil or any other protection, in direct contact with the hot enamel, risks melting and deteriorating the enamel of the insides In order to prevent excessive dirtying of your oven and the resulting strorg smokey smells, we recommend nat using the oven at very high temperature. It s better to extend their cooking title and lower the temperature a little. In addition to the accessories supplied with the over, we advise you only use dishes and taking molds resistant to very high temperatures

Installation

The manufacturers have no obligation to carry this out, If the assistance of the manufacturer is required to rectify faults arising from incorrect installation, this assistance is not covered by the guarantee. The installation instructions for professionally qualified personnel must be followed. Incorrect installation may cause harm or injury to people, animals or belongings The manufacturer cannot be held responsible for such harm or injury The oven can be located high in a column or under a worktop. Before facing, you must ensure good ventilation in the open space to allow proper circulation of the fresh air required for cooling and protecting the integral parts. Make the openings specified on the last page according to the type of fitting.

Waste management and environmental protection

This appliance is labeled in accordance with European Directive 2012/19/EU regarding electric and electronic appliances (WEEE). The WEEE Contains both polluting substances (that can have a negative effect on the environment) and base elements (that can be reused. It is important that they WEEEundergo specific treatments to correctly remove and dispose of the pollutants and recover all the materials. Individuals can play an important role in ensuring that the WEEE does not become an environmental problem; it s essential to follow a few basic rules:

  • The WEEE should not be treated as domestic waste;
  • The WEEE should be taken to dedicated collection areas managed by the town council or a registered company
  • In many countries, domestic collections may be available for large WEEEs When you buy a new appliance, the old one can be returned to the vendor who must accept it free of charge as a one-off as Kang as the appliance in an equivalent type and has the same function the purchased appliance

SAVING AND RESPECTING THE ENVIRONMENT

Where possible, avoid pre-heating the oven and always try to fill it. Open the oven dear as infrequently as possible, because heat from the cavity disperses every area it is open For a significant energy saving. switch off the oven between 5 and 10 minutes before the planned end of the cooking time, and use the residual heat that the oven continues to generate. Keep the seals cean and in order, to avoid any heat dispersal outside of the cavity if you have an electric contract with hourly tariffs, the “delanyed cooking program makes energY Saving more simple, moving the cooking process to start at the Teduced tariff time slat.

Declaration of compliance

  • By placing the CE mark on the appearance, we are confirming compliance to ail relevant European safety, health and environmental requirements which are applicable in legislation for this product.

Product Description

Overview

  1. Control panel
  2. Shelf positions (lateral wire grid if included)
  3. Metal grill
  4. Drip pan
  5. Fan (behind the steel plate)
  6. Oven door

Accessories [According to model]

Drip pan

  • Collects the residues that drip during the cooking of foods on the grills

Metal grill

  • Holds baking trays and plates

Lateral wire gids

  • It is located at both sides of the oven cavity It holds metalgrills and drip pas.

First Use

PRELIMINARY CLEANING

Clean the oven before using it for the first time. Wipe over external surfaces with a damp soft cloth, Was all accessories, and wipe inside the oven with a solution of hot water and washing up liquid. Set the empty over to the maximum temperature and leave on for about 1 hour, this will remove any lingerine smells of newness

Use of the Oven

Display description

Using the end of the cooking timer

This control enables to set the desired cooking time (max. 120 min.) the oven will automatically switch off at the end of the set time The timer will count down from the set time retutn to the O position and switch off automatically For normal use of oven set the timer to the position., To set the have to ensure the timers is not and the Opauition.

Cooking Modes

  • Tested in accordance with e EN 6330-1 LR the purpose of eye condition Deidara about and eery class.

Oven Cleaning and maintenance

General notes on cleaning

The lifecycle of the appliance can be extended through regular cleaning. Wait for the oven to cool before carrying out manual cleaning. operations Never use abrasive detergents, steel wool or sharp objects for cleaning. so as to not irreparably damage the enameled parts. Use only water, soap or bleach based detergernts ammonia)

GLASS PARTS

It is advisable to clean the glass window with an absorbent kitchen towel after every use of the oven. To remove more obstinate stains, you can use a detergent- soaked sponge, well wrung out, and then rinse with water

OVEN WINDOW SEAL

  • If dirty the seal can be cleaned with a slightly damp sponge.

ACCESSORIES

  • Clean accessories with a wet. soapy sponge before rinsing and drying them: avoid using abrasive detergents.

DRIP PAN

  • After using the grill, remove the pan from the oven. Pour the hot fat into a container and wash the pan in hot water, using a sponge and washing up liquid
  • If greasy residues remain, immerse the pan in water and detergent Alternative. you tan wash the pan
  • In the dishwasher or use a commercial oven detergent. Never put a dirty pan back into the oven

Maintenance

REMOVING AND CLEANING WIRE RACKS

  1. Remove the wire racks by pulling them in the direction of the arrows (see below
  2. To clean the wire racks either put them in the dishwasher or use a wet sponge, ensuring that they are dried afterward
  3. After the cleaning process installs the wire racks in reverse order.

REMOVAL OF THE OVEN WINDOW

  1. Open the front window
  2. Open the clamp of the hinge housing on the right and left side of the front window by putting them downwards
  3. Replace the window by carrying out the procedure in reverse.

REMOVAL AND CLEANING OF THE GLASS DOOR

  1. Open the oven door
  2. LDckthe hinges, remove the screws, and remove the upper metal cover by pulling it upwards
  3. Remove the glass, carefully extracting it from the oven door (NB: in pyrolytic ovens, also remove the second and third glass flip present)
  4. At the end of cleaning or substitution, reassemble the parts in reverse order.
  5. All glass with the indication “Pyro” must be legible and positioned on the left side of the door, close to the left-hand lateral hinge. In this way, the printed label of the first glass will be inside the door.

CHANGING THE BULB

  1. Cisconniectthe oven from the mains supply
  2. Undo the class cover, unscrew the bulb and replace it with a new bulb of the same type
  3. Once the defective bulb is replaced, replace the gas cover