Philips HR2041 3000 Series Blender User Manual

HR2041 3000 Series Blender
User Manual HR2041

Introduction

Congratulations on your purchase and welcome to Philips!
To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome.

Important

Read this important information carefully before you use the appliance and save it for future reference.
Danger

Never immerse the motor unit in water or any other liquid, nor rinse it under the tap. Use only a moist cloth to clean the motor unit.

Warning

Thoroughly clean the parts that come into contact with food before you use the appliance for the first time.
Check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance.
If the main cord is damaged, you must have it replaced by Philips, a service center authorized by Philips, or similarly qualified persons in order to avoid a hazard.
Do not use the appliance if the plug, the main cord, or other parts are damaged.
Never use the blender jar or accessories to switch the appliance on and off.
Never let the appliance run unattended.
This appliance shall not be used by children. Keep the appliance and its cord out of reach of children.
Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and if they understand the hazards involved.
Children shall not play with the appliance.
Do not touch the blades, especially when the appliance is plugged in. The blades are very sharp.
Do not pour hot liquid into the food processor or blender as it can be ejected out of the appliance due to a sudden steaming.
The appliance is intended to be used in households only.

Caution

Switch off the appliance and always disconnect from supply if it is left unattended and before assembling, disassembling, or approaching parts that move in use, or cleaning.
Never use any accessories or parts from other manufacturers that Philips does not specifically recommend. If you use such accessories or parts, your warranty becomes invalid.
Do not exceed the maximum indication on the blender jar and the mill/chopper.
Do not exceed the maximum quantities and processing times indicated in the relevant table.
The appliance can only be switched on if the blender jar or the mill/chopper is assembled on the motor unit correctly.

Blender

Warning

Never reach into the blender jar with your fingers or an object while the
appliance is running.
Make sure the blade unit is securely fastened to the blender jar before
you assemble the blender jar onto the motor unit.
Do not touch the cutting edges of the blender blade unit when you
handle or clean it. They are very sharp and you could easily cut your
fingers on them.
If the blade unit gets stuck, unplug the appliance before you remove the
ingredients that block the blades.

Caution

In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
Do not misuse the appliance to avoid potential injury.
Never fill the blender jar and accessories with ingredients hotter than 60°C.
Do not use the glass blender jar right after taking it out from the dishwasher or refrigerator. Let it stay at room temperature for at least 5 minutes before use.
To prevent spillage, do not exceed the maximum volume indication on the blender jar, especially when you process at a high speed. Reduce the amount of the ingredient that tends to foam in the jar/accessory.
If food sticks to the wall of the blender jar, switch off the appliance and unplug it. Then use a spatula to remove the food from the wall.
Always make sure the lid is properly closed/assembled on the jar and the measuring cup if any is inserted properly in the lid before you switch on the appliance.
Do not let the appliance run for more than 2 minutes at a time.
Always let the appliance cool down to room temperature after each batch you process.
Noise level: Lc = 86dB(A)

Mill/Chopper

Warning

Make sure the blade unit is securely fastened to the mill/chopper before you assemble the mill/chopper onto the motor unit.
Never use the mill/chopper to grind very hard ingredients such as nutmeg, rock sugar and ice cubes.
Do not touch the cutting edges of the mill/chopper blade unit when you clean it. They are very sharp and you could easily cut your fingers on them.

Caution

Never use the mill/chopper for more than 30 seconds without interruption.
Always let the appliance cool down to room temperature after each operation.

Built-in safety lock

This feature ensures that you can only switch on the appliance if the blender jar or accessories is assembled on the motor unit properly. If the blender jar or accessories is correctly assembled, the built-in safety lock will be unlocked.

Overheat protection

The appliance is equipped with overheat protection. If the appliance overheats, it switches off automatically (which might occur during heavy processing jobs or if the appliance is not used according to the instructions in the user manual). If this happens, first switch off and unplug the appliance and let it cool down to room temperature. Then check if the quantity of ingredients you are processing does not exceed the quantity mentioned in the user manual or if something is blocking the blade unit. Then put the mains plug back into the power outlet and switch on the appliance again.

Electromagnetic fields (EMF)

This Philips appliance complies with all standards regarding electromagnetic fields (EMF).

Recycling
This symbol means that this product shall not be disposed of with normal household waste (2012/19/EU).
Follow your country’s rules for the separate collection of electrical and electronic products. Correct disposal helps prevent negative consequences for the environment and human health.

Guarantee and support

If you need service or information or if you have a problem, please visit the Philips website at www.philips.com/welcome or contact the Philips Consumer Care Centre in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in your country, go to your local Philips dealer.

Download

Philips HR2041 3000 Series Blender User Manual

Was this manual helpful?