Mitsubishi Electric D12-GR Electric Desk Fan Instruction Manual

MITSUBISHI ELECTRIC D12-GR Electric Desk Fan

PART NAME

HOW TO ASSEMBLE

  1. Before installation, unscrew a Hexagon head bolt which attached with bottom of Stand (Fig.G))
  2. Thread power cord through the backside hole of base cover(Fig.®)
  3. After assemble the stand and base cover together, fix the power cord to the retaining hold of base cover ()
  4. Re-screw the removed Hexagon head bolt as Fig.G)to fit tightly between the stand and the base cover ()

HOW TO USE

  • Press one of the three push button switch (1, 2 or 3) to turn the fan on.
    • Press “O” to turn off.
    • Press “1” for the lowest fan speed.
    • Press “2” for the medium fan speed.
    • Press “3” for the highest fan speed.

OSCILLATION

  • Press Knob K to start fan oscillation.
  • Pull Knob K to stop fan oscillation.

AIRFLOW DIRECTION

  • The air flow direction can be adjusted up, down, left or right by gently hold the stand and adjust the motor as desired.

HEIGHT ADJUSTMENT MODEL: R16-GD/ GD-P, R18-GD/GD-P 

  • To raise the level of the fan, press the slide knob together with pulling up the motor part to the desired height.
  • To lower the level of the fan, press the slide knob together with lowering the motor part to the desired height.

warning
Do not press slide knob unless assemble the guard and propeller fan because the motor part quickly slide up and cause injury.

CAUTION

  1. Do not put fingers or anything into the guard. The blade might be damaged and cause injury.
  2. Do not use the fan in
    • Room temperature over 45 °c
    • Very humid are
    •  Near fire or wet area
    • Area containing high amount of fuel, chemicals or dust.
  3. Do not apply any kind of spray. Otherwise, the plastic parts might be -damaged or deformed.
  4. Do not use the fan near curtain because it can cause damage and accidents.
  5. It is strongly advised, not to blow the fan wind directly toward body for a long time especially / for patient, infant and elderly. Ii
  6. If the supply cord is damaged, it must be replaced by a qualified technician or MITSUBISHI ELECTRIC’s Service Centers.

Power cord caution

  • Do not make pinched
  • Do not make overload on
  • Do not bend
  • Do not twist
  • Do not pull on
    It is may cause electric shock, and fire.

CARE INSTRUCTION

  1. The fan must switch off from supply mains before removing the guard.
  2. To prevent accidents,always unplug the fan before cleaning. Also keep electrical parts out of water.
  3. Clean the dirty parts (propeller fan, stand, base, guard, etc.) by using soft cloth, soaked and damped in warm water or mild detergent then wipe dry with soft cloth.
  4. Do not use volatile chemicals (gasoline, benzene, thinner, spray cleaner, alcohol, etc.)or other chemicals (treated dust cloths, alkaline soap solutions, boiling water, cleaner, etc.) for cleaning because
    all of these can damage the plastic parts.
  5. If a large amount of dust collects on the propeller fan, it may cause overheating or excessive vibration of the motor. This can lead to burn out and other damages, so be sure to keep the propeller fan clean.
  6. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
  7. Children should be supervised to ensure that do not play with the appliance.