Philips E27 TrueForce LED Road Lamp Installation Guide

PHILIPS E27 TrueForce LED Road Lamp

Installation

Philips TrueForce LED Road Lamp
Please take the time to read this installation guide. The guide contains important information and notes regarding the installation and operation.

IMPORTANT

  • The product works ONLY with an existing ElectroMagnetic (EM) gear (refer to True Force LED lamps to ballast – igniter compatibility list). No need to rewire or modify the luminaire, the igniter can stay in the system.
  • The product is designed to fit in standard IEC-compliant E40 lamp holders.
  • Always switch off the power supply before commencing work!
  • Please read the installation instructions carefully to ensure safety.
  • The product is not dimmable.
  • The product is not compatible with electronic gear.
  • The product DOES NOT work on Direct Mains.
  • Suitable for use in operating temperature range between -40°C to +45°C.
  • Do not change the structure or any components of the product to ensure safety.
  • The product should be installed by a professional electrician.
  • Perform inspection before installation to ensure the luminaire and lamp holder are in good condition to carry the weight and performance of the product.
  • The product fulfills IP40 requirements, outdoor applications require the lamp to be used in luminaires with a suitable IP rating.
  • Please do not apply the product in applications that contain emergency or/and explosive-proof luminaires.
  • The total system performance may vary depending on the lighting/luminaire system.
  • For the latest information, please refer to www.philips.com/lighting.
  • In case of doubt, please consult Philips’s representative.
  • The minimum dimensions requirement for the lamp compartment is (L x 12l) 280mmX 180mm. Please check the Tc temperature in the application guide for best performance.
  • Do not install any lamp which is deformed or damaged from transportation or handling.
  • Compatible with EM ballasts SOHz only.
  • Keep lamps clear during application (esp. no oil contamination on glass tube), to ensure good lamp performance.

SON/HPL lamps with EM gear

DISCLAIMER

Signify disclaims liability for any direct, indirect, or incidental damages in case of installation performed either not according to this guide or not performed by a professional electrician.